Panasonic SC-HT280 - Manuel (Page 17)

1
A SPEAKERS B
^-SPEAKERS-A
sD J
TEST
\ I ! i
L- C - R - RS^LS-SW
«1 - VOL +
oo
LEVEL
/ /_/ //
/ // / /7
C— RS-* LS-SW
t_______________ I
Preparatory steps
Do these steps to get the most from your home theater system.
Adjusting speaker output level
Adjust speaker level so the output from all the speakers is the
same apparent level when sitting where you would normally enjoy
a source.
1
Press [A] to turn on the SPEAKERS A.
You cannot adjust when SPEAKERS B is selected.
by remote control only
Press [TEST] to output the test signal.
“TEST” appears on the display.
The signal is output from each speaker in order for about
two seconds each:
L: Front speaker (left)
C: Center speaker
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as "NONE" or “OFF’ are skipped.
DSP switches to SURROUND mode when the test starts.
by remote control
Press [VOL (- or +)] to set the volume
level normally used for enjoying the
source.
Use [BALANCE] if the left right balance of the front
speakers is off.
by remote control only
Press [LEVEL] to select the speaker
channel to adjust.
The current level appears o n the display.
Press again to change the speaker channel.
Speakers set as "NONE” or "OFF" are skipped.
by remote control only
Press [-] or [+] to adjust the level to
the same apparent level as the front
speakers.
C, RS, and LS can be adjusted between -10 dB and +10
dB, with zero being the current level of the front speakers.
SW can be adjusted between 1 and 25.
6 Repeat 4 and 5 for each speaker
channel.
To stop the test signal
Press [TEST].
The test signal will not be output if DSP DEFEAT is engaged.
Ensure DSP is ON Page 19).
c
.O
2
s.
I
ROT5307