Panasonic PanaSync E50 - Manuel (Page 12)

( Power Management Systern)
This monitor meets VESA (Video Electronics Standards Association) DPMS Ptsplay Power
Management Signaling) standards. In order for the monitor’s power saving feature to func­
tion, the video board or computer must also meet VESA® DPMS™ standards.
state Power LED Power Recovery time
On Green Normal Not Applicable
Standby Amber S 30 Watts About 3 seconds
Suspend Amber ^ 30 Watts About 3 seconds
Off Amber ¿ 5 Watts About 8-10 seconds
Note: The Power Management System "Off State is different from the "Off state of the
Power Switch. When The Power Switch is "Oft" the Power LED is dark.
The monitor goes into various power saving stages depending on the incoming video
signal as shown in the following table.
State Horizontal Sync Vertical Sync
On Pulses Pulses
Standby No Pulses Pulses
Suspend Pulses No Pulses
Off No Pulses No Pulses
The monitor automatically goes through the PMS (Power Management System) states
when there are no Horizontal and/or Vertical syrtc pulses. To release the monitor from a
PMS state, press any key on the computer keyboard.
NOTE:
Pressing the monftor Power Switch when the computer Is in the PMS state will not
recall the screen Image, you must touch any key on the keyboard or move the
mouse to restore the Horizontal and/or Vertical Sync output from the computer.
— 10 —