Panasonic CQ-DPG550 - Manuel (Page 17)

Installation Guide
A
WARNING
The installation information is designed for experienced installers and is not
intended for non-technical individuals. It does not contain warnings or cautions of
potential dangers in attempting to install this product.
Any attempt to install this product in a motor vehicle by anyone other than
qualified installer could cause damage to the electrical system and could result in
serious personal injury or death.
□ Overview
This equipment should be installed by a
professional. However, if you plan to install this
unit yourself, your first step is to decide where to
install it. The instructions in these pages will
guide you through the remaining steps: (Please
refer to “WARNING” statement above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
• Check the operation of the unit
If you do encounter problems, please consult
your nearest professional installer.
Caution: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so
could cause serious damage. * •
Before you begin installation, look for the
following items included in the packing with your
unit.
• Warranty Card .... Fill this out promptly
• MSC, Panasonic (in Canada) Servicenter
Directory .... Keep for future reference in case
the unit needs servicing
• instaiiation Hardware ....Needed for in-dash
installation
□ Installation Hardware
No. Item Diagram Qty
©
Mounting Collar 1
@
Plain Washer {5 mm<t>)
©
2
Spring Washer (5 mmcft)
©
2
©
Hex. Nut (5 mm(t>) 2
Rear Support Strap 1
®
Hex. Bolt
(5 mnriij) X 25 mm)
1
@
Toothed Lock Washer
(5 mm({)) %
1
®
Mounting Bolt (5 mm^) 1
Power Connector 1
Remote Control Unit
(Only for CQ-DPG550EUC) 1
®
Lithium battery
(Only for CQ-DPG550EUC)
©
1
(g) Removable Face Plate
Soft Case
1
CQ-DPG550/DPG500EUC
17