Attwood Wireless Foot Pedal - Manuel

Direction Control
Pivot the foot pedal toe-down to steer right, or heel-down to steer left. To stop turning, allow the pedal to return
to its center detent position without pressing down on the heel or toe of the pedal. To operate the motor in reverse,
continue to press the foot pedal down in either direction until the head is pointing to the desired direction of travel.
The available steering range will allow the operator to steer the trolling motor past 360° in either direction.
a - Toe-down position—right turn
b - Center detent position— steering off
c - Heel-down position—left turn
Speed Control
Control the speed of the trolling motor by adjusting the speed control dial on
the foot pedal. Rotate the dial forward to increase motor speed, and rotate it
backward to reduce speed. Press and hold the momentary button to operate
the motor at the selected speed. Release the momentary button to stop the
motor. Press the propeller constant on/off button once to run the motor at the
selected speed. Press the button again to turn the motor off. The motor speed
can be adjusted while the motor is running.
a - Speed control dial—rotate forward to increase speed
b - Momentary button
c - Propeller constant on/off button
Foot Pedal Battery Replacement Two AA alkaline batteries required
1. Remove the two screws securing the battery cover plate. Remove the battery cover plate.
a - Battery cover plate
b - Screws
2. Remove the batteries from the battery holder.
3. Install the new batteries in the proper orientation for correct polarity.
4. Ensure the rubber seal is positioned correctly around the battery cover plate.
5. Replace the battery cover plate and install the two screws. Tighten the
screws securely.
cover plate.
Activating the Wireless Foot Pedal
Each wireless foot pedal has a unique serial number and must be synced individually to the trolling motor
receiver. The trolling motor receiver can sync up to 40 wireless controllers. This ensures that the trolling
motor will respond to commands only from designated controllers. Follow the instructions below to activate
the wireless foot pedal with your trolling motor.
IMPORTANT: To activate multiple foot pedals, the motor must be unplugged from the power
source and then plugged back into the power source between activating each control device.
1. Connect the battery cables to the battery, or plug in the battery cable to a power source. Within ten
seconds of connecting the battery cables to their terminals, press and hold the propeller and anchor
buttons on the wireless foot pedal simultaneously.
2. Listen for a multitone beep, indicating that the receiver has synced the
electronic serial number.
a - Anchor button (foot pedal on/off)
b - Propeller button (propeller on/off)
3. To turn the Foot Pedal On or Off, press and hold the anchor hold button.
One short beep from the foot pedal indicates that the foot pedal is turned
on; two short beeps indicate that the foot pedal is turned off.
Foot Pedal Operation
Wireless
Foot Pedal
© 2014, MotorGuide © 2014, MotorGuide For questions, contact Consumer Affairs at 1-920-929-5040
www.motorguide.com For questions, contact Consumer Affairs at 1-920-929-5040
www.motorguide.com 69529 RevA 69529 RevA
Instruction Sheet
#90100007
WARNING!
Rotating propellers can
cause serious injury or
death. Never start or operate
the motor out of water.
WARNING!
Avoid possible serious injury from unexpected
acceleration and boat movement when activating the trolling motor.
When using the foot-pedal, the motor will start up at the last selected
speed and course settings. Before pressing the foot-pedal, hold on to a
seat or handhold, and advise passengers to do the same.
a - Toe-down position—right turn
b - Propeller momentary on/off
c - Propeller constant on/off
d - Heel-down position—left turn
e - Anchor button—models with GPS installed; also foot pedal on/off
f - Speed control dial
WARNING!
Avoid possible serious injury from unexpected acceleration and boat movement
when activating the trolling motor. When using the foot-pedal, the motor will start up at the last selected
speed and course settings. Before pressing the foot-pedal, hold on to a seat or handhold, and advise
passengers to do the same.
a
f b
c
c
b
c
d
a
e
b
a
b
a
a
c