CCI Thermal Technologies SHMK - Swivel Hanging Mounting Kit - Manuel

CONTENTS
Item Qty. Description
 2 Angle Hanger
 2 Connector Hanger
 2 Adaptor Hanger
 5 Bolt, 1/2 UNC x 1-1/4
 4 Nut, 1/2 UNC
 5 Lock Washer, 1/2”
 1 Mtg Attach Assy Bracket
 1 Swivel Mtg Attach Assy
 3 Flat Washer, 1/2”
STEP 4
Screw Hanger Assemblies to
the Swivel Mtg Attach Assy

.
Swivel Hanging Mounting Kit Installation Instructions
For Heat Exchanger Unit Heaters
(En français à l’endos.)
STEP 3
Bolt Mtg Attach Assy Bracket

to the heater using 1/2
UNC x 1-1/4 bolts, lock
washers, flat washers, and 1/2
UNC nuts.
STEP 2
Screw one Connector Hanger

and one Adaptor Hanger

onto each steel pipe until
tight (minimum of 5 turns
each).
Pipe cut length = Distance
from support structure to top
of heater
LESS 9-3/8” (238mm)
STEP 1
Fasten Angle Hangers  to a surface
or structure that will support the heater’s
weight using the installer supplied
fasteners. Refer to the owner’s manual
for the heater’s weight.
Installer required to supply:
a) a method of fastening the Angle Hangers  to the supporting structure that is at least as strong as four 3/8”
diameter, grade 5 bolts (see step 1) and,
b) two pieces of 1/2”, schedule 40 or heavier, steel pipe cut to suit required installation length and threaded at both
ends (see step 2).
Check that your heater model number corresponds to the model number shown on the mounting kit carton.
Printed in Canada. Copyright 2008. All rights reserved. Part No. 5756-2
STEP 5
Hang assembly from Angle
Hangers ¿ using two 1/2 UNC
x 1-1/4 bolts, lock washers,
and nuts.
STEP 6
Connector Hanger

must be
hung on the inside of Angle
Hanger

as shown. Rotate
Connector Hanger

to align
with Angle Hanger  Do not
back off more than 3/4 turns.
Bolt the Swivel Mtg Attach
Assy

to the Mtg Attach
Assy Bracket  using a 1/2
UNC x 1-1/4 bolt, lock washer,
and flat washer. Swivel heater
to desired orientation and
secure in place.

 


Support
structure








Heater
may be
rotated as
indicated
by arrows
1/2” Sch. 40, or
heavier Steel pipe




10-1/8”
(258 mm)
4-1/2”
(114 mm)
Support structure
Installer supplied
fasteners
WARNING:
If the heater is installed on a structure that is to be transported, provide additional support for the
heater during transit. The suspended weight should not exceed 300lbs (136kg). Refer to the
owner`s manual for mounting specifications and conditions.