Enerpac 11-400 Manuel d'utilisation

Instruction sheet, Index

Advertising
background image

1

Instruction Sheet

11-100 and 11-400

High Pressure

Stainless Steel Handpumps

L-1038

05/’99 Rev. B

®

1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If
shipping damage is found notify carrier at once. The
carrier is responsible for all repair and replacement
costs resulting from damage in shipment.

SAFETY FIRST

Read all instructions, warnings and cautions
carefully. Follow all safety precautions to avoid
personal injury or property damage during system
operation. Enerpac cannot be responsible for
damage or injury resulting from unsafe product use,
lack of maintenance or incorrect product and/or
system operation. Contact Enerpac when in doubt as
to the safety precautions and applications. If you
have never been trained on high-pressure hydraulic
safety, consult your distribution or service center for
a free Enerpac Hydraulic safety course.

2.0 PRODUCT DESCRIPTION
2.1 Applications
These pumps are used for hydrostatic testing
applications and to power cylinders and tools
requiring 10000 PSI [700 bar] or higher. They are
made from 303 stainless steel and have self-aligning
stainless steel piston drives.

2.2 Following fluids can be used with these
pumps:

Distilled Water

Alcohol

Diesters

Silicones

Soluble Oil

Petroleum

2.3 Specifications
See table 1 on page 4 for technical specifications.

3.0 GENERAL SAFETY ISSUES

Failure to comply with following cautions
and warnings could cause equipment
damage or personal injury.

A CAUTION is used to indicate correct operating or
maintenance procedures and practices to prevent
damage to, or destruction of equipment or other
property.

A WARNING indicates a potential danger that
requires correct procedures or practices to avoid
personal injury.

A DANGER is only used when your action or lack of
action may cause serious injury or even death.

WARNING:

Wear proper personal

protective gear when operating hydraulic
equipment.

WARNING: Do not exceed equipment
ratings.
Never attempt to lift a load
weighing more than the capacity of the
cylinder. Overloading causes equipment

failure and possible personal injury. The cylinders are
designed for a max. pressure of 10000 psi [700 bar].
Do not connect a jack or cylinder to a pump with a
higher pressure rating.

index:

English Instruction Sheet ......................................................... page ........ 1-4

Français Notice d’Emploi .......................................................... page ........ 5-9

illustration 1

Reservoir Filler Plug

Outlet Gland Nut
and Plug

Release Valve

Gauge Port Gland Nut
and Plug

Advertising
Ce manuel est liée aux produits suivants: