Whirlpool WDL785SAAM - Manuel (Page 7)

7
■ To add rinse aid, turn the dispenser
cap to “Refill” and lift off. Pour rinse
aid into the opening until the
indicator level is at “Full.” Replace
the dispenser cap and turn to
“Lock.” Make sure cap is fully
locked.
NOTE: For most water conditions, the factory setting will give good
results.
■ Check the water hardness level to ensure no rings or spots on
your dishware before adding rinse aid or adjusting the factory
setting.
■ If you have hard water or notice rings or spots, try a higher
setting.
Turn the arrow adjuster inside the
dispenser by either using your
fingers or inserting a flat-blade
screwdriver into the center of the
arrow and turning.
Select a Cycle (cycles vary by model)
See “Cycle and Option Descriptions” charts in the following
section.
Heavier cycles and options affect cycle length.
Select Options (options vary by model)
See “Cycle and Option Descriptions” charts in the following
section.
You can customize your cycles by pressing the options desired.
Start or Resume a Cycle
■ Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water. For best dishwashing results, water
should be 120ºF (49ºC) as it enters the dishwasher.
■ For models with controls on top of the door, select
wash cycle, option and press START/RESUME
before closing the door. Push door firmly closed.
The door latches automatically. Select the wash
cycle, options and press STAR/RESUME or press
START/RESUME to repeat the same cycle and
options as in the previous wash cycle.
■ You can add an item anytime at the beginning of the cycle.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
Lock
Refill
6 5 4
3
2
- -
-
max
fill
1
- -
-
-
- - -
-
-
-
-
- -
-
max
fill
- -
-
-
- - - -
-
-
-
-
STEP 3
STEP 4
¹⁄₄ turn to lock