Refrigerator use, Using the controls – Whirlpool WRT311FZBM Manuel d'utilisation

Page 14

Advertising
background image

14

Installing the Produce Preserver

The produce preserver pouches should be installed in the
housing, located on the wall of one of the crisper drawers.

1. Remove the FreshFlow™ Produce Preserver pouches from

the packaging.

2. Lift up on the housing to remove it from the mounting tab.
3. Open the housing by pulling up and out on the back of the top

of the housing.

4. Place both pouches inside the housing, then snap the housing

back together.

5. Place the housing back on the mounting tab.

Installing the Status Indicator

The produce preserver comes with a status indicator, which
should be activated and installed at the same time the pouches
are installed.

1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator until

the bubble pops, to activate the indicator.

3. Slide open the cap on the top of the produce preserver

housing.

4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible

through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator’s bubble
has not been popped.

Replacing the Produce Preserver

The disposable pouches should be replaced every 6 months,
when the status indicator has completely changed from white to
red.
To order replacements, contact us. See “Accessories” for
information on ordering.
1. Remove the used pouches from the produce preserver

housing.

2. Remove the used status indicator.
3. Install the replacement pouches and status indicator using the

instructions in the previous sections.

REFRIGERATOR USE

Using the Controls

The temperature controls are located at the top front of the
refrigerator or freezer compartments.

Temperature Controls

For your convenience, the temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
Style 1 - Electronic

Recommended Setting “3rd Snowflake”

Style 2 - Dial

Recommended Setting “3 Snowflakes”

IMPORTANT:

The recommended setting should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream is
firm.

Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has cooled
completely, your food may spoil.

NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.

If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.

Adjusting Controls

If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart below as
a guide.
Style 1 - Press the TEMP button to display the desired number of
snowflakes from (1 snowflake [least cold] to all snowflakes
[coldest]).

CAUTION: IRRITANT

MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES
FORM WHEN MIXED WITH OTHER PRODUCTS.

Do not mix with cleaning products containing ammonia,
bleach or acids. Do not get in eyes, on skin or clothing. Do
not breathe dust. Keep out of reach of children.

FIRST AID TREATMENT: Contains potassium
permanganate. If swallowed, call a Poison Control Center or
doctor immediately. Do not induce vomiting. If in eyes, rinse
with water for 15 minutes. If on skin, rinse with water.

CA

UTION

IR

R

IT

A

N

T

Read cautions on bac

k.

A

TTENTION

IR

R

IT

A

N

T

Lisez des pr

udences sur le re

v

e

rs

.

MONTHS

REPLACE

Advertising