Sony DR-BT100CX - Manuel (Page 10)

DR-BT100CX_4-130-037-63(1)
10
US
Pairing
What is pairing?
Bluetooth devices need to be “paired”
with each other beforehand.
Once Bluetooth devices are paired,
there is no need for pairing again,
except in the following cases:
 Pairing information is deleted after
repair, etc.
 This unit is paired with 9 or more
devices. This unit can be paired with
up to 8 devices; if a new device is
paired after 8 devices have been
paired, the device whose latest
connection time is the oldest among
the 8 paired devices is replaced by
the new one.
 When recognition of the unit by the
device to be connected is deleted.
 This unit is initialized (page 25). All
pairing information is deleted.
Procedures of pairing
1
Place the Bluetooth device
within 1 m (3 ft) of this unit.

Press and hold the PAIRING
button for  seconds or more to
standby for pairing while the
unit is turned off.
The indicator (blue) and indicator
(red) flash in turn and the unit
enters into pairing mode.
Note
If pairing is not established within about
5 minutes, pairing mode will be canceled
and this unit will turn off. In this case,
start over from step 1.