Step 1: connecting to the vcr, Step 2: setting the vcr to operate – Sony DCR-TRV22E Manuel d'utilisation

Page 110

Advertising
background image

110

Using Digital program editing on
the tape recorded on other
equipment

Operation 1 Making a programme (p. 117)
Operation 2 Performing Digital program
editing (Dubbing the tape) (p. 120)

Note
When editing digital video, the operation
signals to the VCR cannot be sent with
LANC jack.

Step 1: Connecting to the VCR

You can connect either the A/V connecting
cable or the i.LINK cable.
Connect the devices as illustrated on page 106.

Step 2: Setting the VCR to
operate

When you are connecting the camcorder and
VCR using the A/V connecting cable, the
signal is emitted from the infrared rays emitter
of your camcorder to the remote sensor on the
VCR to control the VCR.

The POWER switch should be set to

1)

/

2)

.

Operate by touching the panel.

1)

DCR-TRV12E/TRV14E

2)

DCR-TRV19E/TRV22E/TRV33E

(1) Turn the power of the connected VCR

on. If the VCR has an input selector, set
it to input.
When you connect a video camera
recorder, set its power switch to VCR/
VTR.

(2) Press FN to display PAGE1.

Dubbing only desired scenes
– Digital program editing (on
tape)

Utilisation de la fonction de
montage numérique de
programmes sur des cassettes
enregistrées avec un autre appareil

Opération 1 Création d’un programme
(p. 117)
Opération 2 Réalisation d’un montage
numérique de programmes (copie d’une
cassette) (p. 120)

Remarque
Pendant le montage de vidéo numérique, les
signaux de fonctionnement transmis vers le
magnétoscope ne peuvent pas être transmis
par la prise LANC.

Etape 1 : Raccordement du
caméscope au magnétoscope

Vous pouvez raccorder les deux appareils soit
avec un cordon de liaison audio et vidéo, soit
avec un câble i.LINK.
Branchez les appareils comme indiqué à la
page 106.

Etape 2 : Réglage du
magnétoscope pour qu’il
fonctionne avec votre caméscope

Lors du raccordement du caméscope et du
magnétoscope à l’aide du cordon de liaison
audio et vidéo, le signal de contrôle du
magnétoscope est émis à partir de l’émetteur
de rayons infrarouges de votre caméscope vers
le capteur de télécommande du magnétoscope.

Réglez le commutateur POWER sur

1)

/

2)

.

Effectuez cette opération à l’aide de l’écran tactile.

1)

DCR-TRV12E/TRV14E

2)

DCR-TRV19E/TRV22E/TRV33E

(1) Mettez le magnétoscope raccordé sous

tension. Si le magnétoscope est doté
d’un sélecteur d’entrée, réglez-le sur
l’entrée.
Lorsque vous connectez un caméscope,
réglez son commutateur d’alimentation
sur VCR/VTR.

(2) Appuyez sur FN pour afficher PAGE1.

Copie de scènes précises
– Montage numérique de
programmes (sur cassette)

Advertising