Troubleshooting – Sony CDX-GT250MP Manuel d'utilisation

Page 15

Advertising
background image

15

Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)

Power requirements: 12 V DC car battery

(negative ground (earth))

Dimensions: Approx. 178

Ч 50 Ч 179 mm

(7

1

/

8

Ч 2 Ч 7

1

/

8

in) (w/h/d)

Mounting dimensions: Approx. 182

Ч 53 Ч 162 mm

(7

1

/

4

Ч 2

1

/

8

Ч 6

1

/

2

in) (w/h/d)

Mass: Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories:

Card remote commander: RM-X151
Parts for installation and connections (1 set)

Optional accessories/equipment:

for CDX-GT350MP

BUS cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
Interface adaptor for iPod: XA-120IP
HD Radio™ tuner: XT-100HD

Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.

Design and specifications are subject to change
without notice.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.

General

No power is being supplied to the unit.

• Check the connection or fuse.
• If the unit is turned off and the display disappears, it

cannot be operated with the remote commander.

t Turn on the unit.

The power antenna (aerial) does not extend.

The power antenna (aerial) does not have a relay box.

No sound.

• The ATT function is activated.
• The position of the fader control “FAD” is not set for

a 2-speaker system.

No beep sound.

• The beep sound is canceled (page 10).
• An optional power amplifier is connected and you are

not using the built-in amplifier.

The contents of the memory have been erased.

• The RESET button has been pressed.*

1

t Store again into the memory.

• The power supply lead or battery has been

disconnected or it is not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.

The leads are not matched correctly with the car’s
accessory power connector.

During playback or reception, demonstration
mode starts.

If no operation is performed for 5 minutes with
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 10).

The display disappears from/does not appear
in the display window.

• The dimmer is set to “DIMMER-ON” (page 10).
• The display disappears if you press and hold

(SOURCE/OFF).

t Press (SOURCE/OFF) on the unit until the

display appears.

• The connectors are dirty (page 13).

The Auto Off function does not operate.

The unit is turned on. The Auto Off function activates
after turning off the unit.
t Turn off the unit.

continue to next page

t

Advertising
Ce manuel est liée aux produits suivants: