Sony STR-DA4400ES - Manuel (Page 15)

15 GB
You can use the supplied remote to operate the
receiver and to control the Sony audio/video
components that the remote is assigned to
operate.
Main remote commander
(RM-AAL016)
The RM-AAL016 remote is used for
illustration purpose.
Remote commander
Name Function
A AV ?/1 (on/
standby)
Press to turn on or off the audio/
video components that the
remote is assigned to operate
(page 124).
If you press ?/1 (2) button at
the same time, it will turn off
the receiver and other Sony
components (SYSTEM
STANDBY).
Note
The function of the AV ?/1
switch changes automatically
each time you press the input
button (5).
B ?/1 (on/
standby)
Press to turn the receiver on or
off.
If zone 2 or zone 3 is selected,
only the main receiver is turned
on or off with this button. To
turn off all components
including an amplifier in zone 2
or zone 3, press ?/1 and AV ?/
1 (1) at the same time
(SYSTEM STANDBY).
Saving the power in
standby mode.
When “Control for HDMI”
(page 115) and “RS-232C
Control” (page 116) are set to
“OFF.”
C ZONE
Press to switch the zone 2 or
zone 3 operation (page 83).
D AMP
Press to enable the receiver
operation (page 41).
E Input
buttons
Press one of the buttons to
select the component you want
to use. When you press any of
the input buttons, the receiver
turns on. The buttons are
factory assigned to control Sony
components (page 53, 87). You
can program the remote to
control non-Sony components
following the steps in
“Programming the remote”
(page 124).
F TV INPUT
Press TV (wf), then press TV
INPUT to select the input signal
of a TV.
G WIDE
Press TV (wf), then press
WIDE repeatedly to select the
wide picture mode.
continued