Sony VPL-5400ES - Manuel (Page 51)

51 GB
G
e
tting Star
te
d
6
Press V/v repeatedly and to
un-check the items you do not
want to measure, then press
b.
The confirmation screen, asking whether
you are ready to start measurement,
appears.
7
Press to select “Start.”
The measurement starts in five seconds.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
8
Press to select “Next.”
“Save auto calibration (auto speaker
setup)?” appears. To save the
measurement results, follow the steps in
“Saving the measurement results”
(page 52).
If a warning message or error code
appears on the screen, see “Message list
after auto calibration measurement”
(page 53).
Note
When the speaker(s) is (are) out of the phase, “Out
Phase” is displayed on the TV screen. The “+” and
“–” terminals of the speaker may be connected the
other way around. However, depending on the
speakers, “Out Phase” appears on the TV screen
even though the speakers are connected properly.
This is because of the speakers’ specifications. In
this case, you can continue to use the receiver.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• In the following situations, the measurements have
not been performed correctly or auto calibration
cannot be performed.
– when connecting special speakers, such as
dipole speakers.
– when using the zone 2/zone 3 function in zone 2/
zone 3.
• The displayed unit of distance for models for
U.S.A. and Canada is feet. The unit of distance for
models for countries/areas other than U.S.A. and
Canada is meters. You can change the unit of
distance use in “Distance Unit” in the Speaker
settings menu.
To cancel the measurement
The measurement is cancelled when you
change the volume, switch functions, change
the setting of the SPEAKERS switch, or
connect headphones.