Warning, Make gas connection – Whirlpool W10477533B Manuel d'utilisation

Page 8

Advertising
background image

8

3. Determine and mark centerline of the cutout space. The

mounting can be installed on either the left side or right side
of the cutout. Position mounting bracket against the wall in
the cutout so that the V-notch of the bracket is 12

⁵³⁄₆₄"

(32.6 cm) from centerline as shown.

4. Drill two

¹⁄₈" (3 mm) holes that correspond to the bracket

holes of the determined mounting method. See the following
illustrations.

Floor Mounting

Wall Mounting

5. Using the Phillips screwdriver, mount anti-tip bracket to the

wall or floor with the two #12 x 1

⁵⁄₈" screws provided.

6. Move range close enough to opening to allow for final gas

and electrical connections. Remove shipping base,
cardboard or hardboard from under range.

7. Move range into its final location, making sure rear leveling

leg slides into anti-tip bracket.

8. Move range forward onto shipping base, cardboard or

hardboard to continue installing the range using the following
installation instructions.

Make Gas Connection

Typical rigid pipe connection

A combination of pipe fittings must be used to connect the range
to the existing gas line. Your connections may be different,
according to the supply line type, size and location.

1. Apply pipe-joint compound made for use with LP gas to all

pipe thread connections.

2. Using a pipe wrench to tighten, connect the gas supply to the

range.

Typical flexible connection

1. Apply pipe-joint compound made for use with LP gas to the

smaller thread ends of the flexible connector adapters (see B
and F in the following illustration).

2. Attach one adapter to the gas pressure regulator and the

other adapter to the gas shutoff valve. Tighten both adapters.

A. 12

⁵³⁄₆₄

" (32.6 cm)

B. Bracket V-notch

Rear position

Front position

Diagonal (2 options)

Centerline

B

A

A. Pressure regulator

connection fitting

B. 90° elbow

C. Black iron pipe

D. Union

E. Nipple

F. Manual shutoff valve

G. ½" or ¾" gas pipe

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.

Examples of a qualified person include:

licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.

Failure to do so can result in death, explosion, or fire.

G

E

F

C

D

A

B

Advertising