Whirlpool W10477533B - Manuel (Page 16)

16
To Convert Oven Burner
1. Open the oven door and remove oven racks, oven tray, and
flame spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner
air shutter.
3. Locate Natural gas orifice spud stamped “47” in the package
containing literature supplied with the range.
4. Use a
³⁄₈" combination wrench and remove the LP gas orifice
spud.
5. Install the number “47” LP gas spud.
IMPORTANT: Do not overtighten.
6. Place LP gas oven burner spud in plastic parts bag along
with LP gas cooktop burner spuds for future use and keep
with the bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.
Complete Conversion
1. Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
2. Turn the manual shutoff valve in the gas supply line to the
open position.
3. Refer to “Check Operation of Cooktop Burners” in the
“Electronic Ignition System” section for proper burner
ignition, operation and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame ¼" to ½" (0.64 cm to 1.3 cm) long. The outer cone
is not as distinct as the inner cone. Natural gas flames do not
have yellow tips.
4. Close the oven door and turn the knob to “OFF.”
5. Refer to the “Complete Installation” section to complete this
procedure.
A. Oven burner
B. Air shutter
A. Natural gas oven orifice spud stamped with “47”
B
A
A