Nilfisk-ALTO 530cc - Manuel (Page 14)

Page -14- CLARKE TECHNOLOGY 530 Upright Vacuum Operator's Manual
HOW TO USE
(See Fig. 10)
1. Remove electrical cord from hook and plug into
electrical outlet.
2. Slide height adjustment to the desired setting.
3. Press the handle release pedal and pull the handle
to the desired position, the unit will turn on auto-
matically when handle is pulled down. To clean
under, press the pedal again and lower the handle.
4. Vacuum slowly with forward and backward strokes,
covering small areas at a time. The time required to
clean the carpet will depend on type of carpet and
amount of dirt.
5. The unit will turn off automatically when the handle
is returned to the vertical position.
Fig. 10
Fig. 11
HEIGHT ADJUSTMENT
The front of the cleaner has a continuous height
adjustment which raises or lowers the cleaner base to
match the type of carpet. With the cleaner cord
unplugged, set the adjustment according to your
specific needs (Fig. 11).
While the cleaner is off and disconnected from the
outlet, tilt the cleaner back to remove weight from the
front wheels, and adjust the setting.
Plug the cleaner into electrical outlet, press the handle
release, lower handle and pass the cleaner over the
carpet. If the cleaner is difficult to push, follow the
procedure and test the cleaner at the next height
setting until the unit is comfortable to move. the brush
roll must make contact with the carpet for effective
cleaning.
Store
Apagado
Éteint
Operate
En operacion
En marche
Clean under
Aspirado por debajo
Aspiration en dessous
Height Adjustment
Adjuste de altura
Réglage de la hauteur