Avocent DSR8035 - Manuel (Page 20)

8 DSR2035/8035 Switch Installer/User Guide
Setting up your network
The DSR2035/8035 switching system uses IP addresses to uniquely identify the switch and the
target devices. The DSR2035/8035 switch supports both Dynamic Host Configuration Protocol
(DHCP) and static IP addressing. Avocent recommends that IP addresses be reserved for each
switch and that they remain static while the DSR2035/8035 switches are connected to the network.
For additional information on setting up the DSR2035/8035 switch using the DSView Server
software, and for information on how the DSR2035/8035 switch uses TCP/IP, see the DSView
Installer/User Guide.
Getting started
Before installing your DSR2035/8035 switch, refer to the following lists to ensure you have all items
that shipped with the DSR2035/8035 switch, as well as other items necessary for proper installation.
Supplied with the DSR2035/8035 switch
• Local country power cord
• Rack mounting brackets
• Rack Mounting Bracket Quick Installation Guide
• Two ribbon cables with RJ-45 connectors at each end
• One RJ-45 to DB-9 (male) adaptor for the modem connection
• One RJ-45 to DB-9 (female) adaptor for the SETUP port
• DSR Installer/User Guide (this manual)
• DSR Quick Installation Guide
Additional items needed
• One DSRIQ module per target server or DSRIQ-SRL module per serial device
• One CAT 5 patch cable per DSRIQ module (4-pair UTP, up to 10 meters)
• One CAT 5 patch cable for network connectivity (4-pair UTP, up to 10 meters)
• One USB2 or USB2L DSRIQ module per target server for virtual media sessions
• DSView 3 software
• (Optional) V.34, V.90 or V.92-compatible modem and cables
• (Optional) SPC power control device