Operating the dishwasher, Interrupt a cycle, Delay start – Bosch SHE7PT55UC Manuel d'utilisation

Page 19: Cycle completion signal, Intensive drying, Auto power off

Advertising
background image

18

Interrupt a cycle

1

Press the [On/Off] button to turn the unit off.

2 To resume the cycle, press the [On/Off] button again.

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1

Press the [On/Off] button. Select a cycle.

2 Press the [Delay] button until the displayed time corresponds with

your requirements and press [Start] to activate delay start.

h:01 = 1 hour delay h:24 = 24 hour delay

To cancel delay start:
1

Press the [Delay] button until “h:00” is indicated on the digital display.

2 Press [Start] to save setting.

Cycle Completion Signal

1

Open the door and press the [On/Off] button.

2 Hold down the “A” button (see page 17) and press [Start] until the

display indicates “d:00”. Release both buttons.

3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF and

b:03” = LOUDEST and press [Start] to save setting and close the door.

Intensive Drying

The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1

Press the [On/Off] button.

2 Hold down the “A” button and press [Start] until the display indi-

cates “d:00”. Release both buttons

3 Press the “A” button until the display shows “d:00”.
4 Press the “C” button to turn intensive drying on or off. “d:01” = ON

and “d:00” = OFF and press [Start] to save setting.

Auto Power Off

To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. Auto Power Off can be adjusted from P:00 to P:02.
To change the factory setting (P:01):
1

Press the [On/Off] button.

2 Hold down the “A” button and press [Start] until the display indi-

cates “d:00”. Release both buttons.

3 Press the “A” button until the display indicates “P:01”.
4 Press the “C” button until the display corresponds with your require-

ments.

P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)

5

Press [Start] to save the setting

.

Advertising
Ce manuel est liée aux produits suivants: