Bosch SHE65T55UC - Manuel (Page 18)

17
NOTE: For models with hidden controls, the door must be opened before changing
settings and closed after changing settings.
Buttons are sensitive and should be touched gently. Avoid any grease or food parti-
cals resting on the buttons as they could activate the dishwasher. Wiping and clean-
ing can also activate the dishwasher. For best results, use bare, clean hands when
touching the buttons.
NOTICE: Use caution when opening door during a running cycle. Hot water may
splash out. Open door slowly.
Start the dishwasher
1 Press the [On/Off] button. The LED of the last selected cycle flashes.
2 Select a cycle and desired options and press [Start].
Cancel a cycle
1 Press and hold the [Start] button for approximately 3 seconds until the
display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains.
3 Open the door and press the [On/Off] button.
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button. Select a cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements and press [Start] to activate delay start.
h:01 = 1 hour delay h:24 = 24 hour delay
To cancel delay start:
1
Press the [Delay] button until “h:00” is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal (hidden controls only)
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 16) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF and
“b:03” = LOUDEST and press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1
Press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indicates
“d:00”. Release both buttons
3 Press the “A” button until the display shows “d:00”.
4 Press the “C” button to turn intensive drying on or off. “d:01” = ON
and “d:00” = OFF and press [Start] to save setting.