Dishwasher setup, Water softening system, Using the water hardness test strip – Bosch SPV5ES53UC Manuel d'utilisation

Page 7: Salt, 1 open the screw cap of the salt container

Advertising
background image

5

Dishwasher Setup

Water Softening System

Your dishwasher requires soft water to ensure proper washing results and is

equipped with an internal water softening system. However, if you have a

household water softening system, the internal system provided is not

needed.
For the water softening system to function properly, it will need to use dish-

washer water softening salt. The amount of salt dispensed can be set from

“H:00” to “H:07”. Salt is not required at H:00 (default factory setting). The

amount of salt required depends on the degree of hardness of your tap

water. See Table 1.
1

Open the door (top controls only) and turn the unit on using the [ON/OFF]

button.

2 Hold down the “A” button (see page 4) and press [START] until the

display indicates “H:00”.

3 Release both buttons and press the “C” button to select the desired

setting.

4 Save the selected setting by pressing [START] and close the door (top controls only).

Using the water hardness test strip

Salt

Refill the salt container, using a funnel to pour, right before turning on the unit to

ensure that salt overflow is immediately washed away. This prevents corrosion.

See Figure 1.
1

Open the screw cap of the salt container.

2 Fill the container with water (only required when turning on the unit for the

first time).

3 Add dishwasher salt until the water is displaced and runs out.

4 Refill with salt as soon as the “Refill Salt” or “Salt” LED is lit.
Notice: Never fill the salt dispenser with detergent. It will destroy the water soft-

ening system. To prevent corrosion, refill with salt and immediately begin any cycle.
Note: Do not use salt tablets or any salt other than dishwasher water softening salt.
For more information about ordering salt please contact Customer Service.

Dip the test strip into tap water for a second. Shake

off excess water and wait approximately 1 minute

before comparing results.

After 1 minute the

test strip will show

you the correct

setting

Setting of

internal water

softener

Fill water

softener with

salt?

0

H:00

no

1

H:00

no

2

H:02

yes

3

H:04

yes

4

H:06

yes

Figure 1

Advertising
Ce manuel est liée aux produits suivants: