Avaya 10U100 - Manual (Page 4)

3
14. Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating
instructions because improper adjustments of other controls may result in
damage and will often require extensive work by a qualified technician to
restore the product to normal operation.
e) If the product has been dropped or the base unit has been damaged.
f) If the product exhibits a distinct change in performance.
15. This product requires AC power in order to operate. In order to have phone
service during a power outage, have another telephone available that is
powered only by the telephone line.
16. Keep all product cords and cables away from operating machinery.
Battery Safety
S A V E T H E S E I N S T R U C T I O N S
CAUTION: To reduce the risk of fire or injury to persons, read and follow
these instructions.
1. Use only the battery pack supplied with this product.
2. Do not dispose of the battery pack in a fire. The cell may explode. Check with
local codes for possible special disposal instructions.
3. Do not open or mutilate battery pack. Released electrolyte is corrosive and may
cause damage to the eyes or skin and may be toxic is swallowed.
4. Exercise care in handling the battery pack in order not to “short” the battery
contacts with conducting materials such as rings, bracelets, and keys. The battery
pack or conductor may overheat and cause burns.
5. Charge the battery pack in accordance with instructions supplied with this unit.
6. Observe proper orientation between battery pack and charger contacts.
7. Contact your local, county, or state hazardous waste management authorities for
information on recycling or disposal programs in your area.
8. Important: The new battery pack must be attached to the Remote and
charged in the Charging Well until the Charge Indicator Light goes off
before it can be used away from the Base .
9. The maximum standby time for a freshly charged battery pack is approximately 7
days. The maximum talk time is approximately 6 hours.
60653-01 10U100 UserGuide_r2 5/11/01 12:11 AM Page 3