Attwood 6375D Manuel d'utilisation

Zamak 1-mile combination sidelight, 6375d installation instructions

Advertising
background image

Figure 1

3.

Attach power wires to suitable switch,

1

-amp fuse, and

power source.

4.

Apply marine sealant around base and wire hole. Use #8 screws

to fasten light to deck.

MAINTENANCE

Replace bulb with #90, 7.5 watt type (Attwood #9232):

1.

Remove light from deck. Remove cover retension screws, base

and lens. Replace bulb. (See Figure

1.)

2.

Reassemble and install light.

© 2003 Attwood Corporation

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

REQUIRED FOR INSTALLATION

Drill with

¹⁄₈

" (3mm) and

¹⁄₄

" (6mm) dia. bits.

Screwdriver and two #8 x

³⁄₄

" (19mm) stainless screws.

Suitable marine sealant.

2-conductor, 14-gauge wire for connection to switch and

power supply.

Fuse holder with 1.0-amp (maximum) fuse.

ON/OFF switch (Attwood Numbers: 7563, 7589).

LOCATION

1.

Position light on horizontal (

±

5

°

) deck surface at forward tip of

the bow on boat centerline.

2.

Ensure that there are no front or side obstructions within arc of

visibility (112.5

°

each side).

MOUNTING INSTRUCTIONS

1.

Align center of light with boat centerline. Use base to mark

mounting screw pilot holes. (See Figure

1.)

2.

Drill two

¹⁄₈

" (3mm) pilot holes. Beneath base, drill a

¹⁄₄

" (6mm)

diameter hole for power wires.

Co

v

e

r

Mounting

Scre

ws

(Not Supplied)

Co

v

er Retention

Scre

ws

Lens

Bulb

3

®

Zamak 1-Mile Combination

Sidelight

6375D

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and other

marine accessories are specified more than any other brand by America

’s

best-known boat manufacturers as original equipment. Look to Attwood

for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69305 Rev. B

03-10

Advertising
Ce manuel est liée aux produits suivants: