Nilfisk-ALTO SW 850S B - Manual (Page 55)

ENGLISH USER MANUAL
4 146 0789 000(4)2007-03 A SW 850S B
SAFETY
The following symbols indicate potentially dangerous situations. Always read this information carefully and take all necessary
precautions to safeguard people and property.
The operator's cooperation is essential in order to prevent injury. No accident prevention program is effective without the total
cooperation of the person responsible for the machine operation. Most of the accidents that may occur in a factory, while working
or moving around, are caused by failure to comply with the simplest rules for exercising prudence. A careful and prudent operator is
the best guarantee against accidents and is essential for successful completion of any prevention program.
SYMBOLS
DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to the
paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the User Manual before performing any procedure.
GENERAL INSTRUCTIONS
Specifi c warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
Turn the ignition key to "0" and disconnect the batteries before performing any maintenance/repair
procedure.
This machine must be used by properly trained and authorised personnel only. Children or disabled people
cannot use this machine.
Keep the batteries away from sparks, fl ames and incandescent material. During the normal operation
explosive gases are released.
Do not wear jewels when working near electrical components.
Do not work under the lifted machine without supporting it with safety stands.
When working under the open hood, ensure that it cannot be closed by accident.
Do not operate the machine near toxic, dangerous, fl ammable and/or explosive powders, liquids or
vapours.
If the machine is equipped with lead (WET) batteries, battery charging produces highly explosive hydrogen
gas. Keep the hood open when charging the batteries and perform this procedure in well-ventilated areas
and away from naked fl ames.
When lead (WET) batteries are installed, do not tilt the machine for more than 30° from the horizontal plane
to prevent the highly corrosive acid from leaking out of the batteries. When the machine is to be tilted to
perform maintenance procedures, remove the batteries. –
–
–
–
–
–
–
–
–