Braun 8595 Activator EU - Manual (Page 14)

14
Shaving
If the shaver is locked into the Clean&Charge station,
push the «start cleaning» button (2) to release the shaver
and take it out.
Switch positions
off = (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
(the pivoting cutting system automatically adjusts to
every contour of your face).
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose).
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Tips for the perfect shave
We recommend that you shave before washing, as the
skin tends to be slightly swollen after washing.
Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of beard
growth.
To maintain 100% shaving performance, replace your foil
and cutter block when it is indicated on the shaver display
or when the parts are worn or at least every 18 months.
Shaving with the cord
If the shaver is completely discharged (see section
«Shaver display») and you do not have the time to
recharge in the Clean&Charge station, you may also
shave with the shaver connected to the mains via the
low-voltage adapter.
After shaving
Automatic cleaning
After each shave, return the shaver to the Clean&Charge
station and proceed as described above in the section
«Before shaving». All charging and cleaning needs are
then taken care of. With daily use, a cleaning cartridge
should be sufficient for about 30 cleaning cycles.
The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approximately 8 weeks.
2
1
2
1
3
2
1
8570
full cartrid ge
au to s elec t
empty
start cleanin g
eco normal intensive
clean
3
2 1 o ff
5643350_S4_102 Seite 14 Donnerstag, 16. Dezember 2004 4:10 16