Waterpik Technologies CASCADIA CF-261(C) Manuel d'utilisation

Instruction manual, Have any questions or need assistance

Advertising
background image

Instruction Manual

Models CF-201(C), CF-261(C)

Operation

Installation
Instructions

Hand-Held
Installation

Care and Cleaning
Instructions

Limited Lifetime
Warranty

Your new showerhead will fit a standard 1/2 ” shower arm. Do not

attach this product to a plastic shower arm since it may not

provide adequate support.

Tools are not required. Do not use pipe tape or any other

sealants when installing the showerhead. These materials are not

necessary and may cause the nut to loosen prematurely. Hand

tightening is sufficient to secure the shower thread. Make sure

the washer is in the end of the nut.
1. Remove old showerhead. Clean pipe threads thoroughly.
2. Attach the flexible shower arm collar to the showerhead, being

careful to align the threads of the showerhead to the threads

of the flexible shower arm.

3. Straighten the flexible shower arm before trying to screw onto

the shower pipe. Again, take care in aligning the nut to the

shower pipe so you do not cross threads.

4. While installing, support the showerhead and

hold onto the nut rather than the cover.

Turn only the nut to tighten. Do not twist

the flexible shower arm covering

during installation. (This could

damage the covering and/or

cause the product to malfunction.)

5. Tighten the shower nut onto the pipe

securely by hand. Do not over tighten

or use pliers.

6. Slowly turn on cold water and check for leaks. If leaks occur,

re-tighten all connections.

7. Do not use excessive force in positioning the showerhead

and/or arm.

8. If the showerhead is not maintaining its position, re-tighten the

showered and shower arm nuts.

Clean the filter screen at least once a year, or whenever you

notice a drop in water pressure. To remove, unscrew the nut

from the pipe. Remove screen by turning it counter-clockwise

(pliers may be used) and rinse. The white flow restrictor

beneath filter screen is also removable for cleaning. Tip the

nut and the flow restrictor will fall out. Flow restrictor must be

reinstalled with pointed end facing in. Reinstall filter screen

and rubber washer.
• Cleaning is required when mineral deposits appear on the

spray orifices to maintain proper working conditions.

• Clean the flexible nozzles by rubbing with a finger or soft

bristled toothbrush.

• Soaking and cleaning with household vinegar will help

remove mineral build up.

• Do not clean or rinse any part with harsh chemicals, heavy

duty cleaners or abrasives. This may damage parts or

finish and may void warranty.

Water Pik, Inc. warrants to the original purchaser of this product

that it is free from defects in material and workmanship for as long

as the original purchaser owns the product. Water Pik will at our

election, replace any part of the product which in our opinion is

defective, provided that the product has not been abused,

misused, altered or damaged after purchase. (This includes

damage due to use of tools or harsh chemicals). In the event an

item qualifying for warranty action has been discontinued, we will

replace it with what we deem to be the closest available product.

Water Pik is not responsible for labour charges, installation or other

consequential costs. The responsibility of Water Pik shall not

exceed the original purchase price of the product. Save your

receipt as proof of purchase is required for warranty action.

FN 20007766-F AB

Spray

Change

Button

Collar

Flexible Arm

Shower

Arm Nut

Bracket

Adapter

Spray

Change

Button

5 foot hose

Flow Control

Filter Screen

Washer

Flow Regulator

with O-ring

(black O-ring

faces out)

Showerhead

Nut

Filter

Screen

Flow Regulator

1. Remove old showerhead. Clean pipe threads thoroughly.
2. Slightly loosen swivel collar on bracket.
3. Hand tighten pivot ball to pipe.
4. Hand tighten adaptor to showerhead.
5. Hand tighten hose to adapter and bracket.
6. Place showerhead in bracket.

9.5L per minute maximum

flow is limited by the flow

restrictor. For low water

pressure areas, flow

restrictor may be removed.

To remove, unscrew filter

screen by turning counter-

clockwise. Tip pivot ball

assembly and flow control

will fall out for cleaning or

removal.

Spray Change

Button

Spray Change

Button

To change settings, from

either the full-body spray

or the concentrated power

spray, push the button

atthe base of the

showerhead so it extends

to the opposite side of its

current position. (It will

move horizontally to the

showerhead.)

This product is covered by one or more of the following patents. U.S.: 4,674,687;
5,316,216; 5,449,206(Lic); 5,865,378; 5,997,047(Lic); 6,164,569; 6,164,570; 6,230,989;
6,454,186; 6,626,210; 6,629,651; 6,641,057; 6,739,523; 6,758,826; 7,066,411B2;
7,111,798B2; 7,144,666B2; D406,636; D415,247; D418,902; D418,903; D422,053;
D422,336; D427,661; D440,641; D450,805; D450,806; D450,807; D451,169; D451,170;
D451,171; D451,172; D451,583; D451,980; D452,553; D452,725; D452,897; D453,370;
D453,551; D457,937; D485,887; D490,498; D527,440S; D528,631S; D529,151S;
D533,253S; D577,099S; D577,793S; D581,014S; D590,048S;

Canadian: 94868; 94871;

96859; 96860; 96861; 96862; 96863; 96864; 96865; 96866; 96867; 96891; 96892;
96893; 96894; 96895; 96896; 2,277,060;

Mexico: 15037; 186852; 218192;

Germany: 40105034.3; 40502480; M9706460.2; U.K.: 3,021,116; 3,021,863; 3,021,864;
E.U.: 000341706-0001; 000341706-0002; 000341706-0003; France: 013345;
Switzerland: 128049; China: ZL98802624.4; 93120174.8; ZL200530004083.3;
Hong Kong: 1003339; South Korea: 389207; Australia: 726023; Singapore: 44333;
Japan: 1230114; Additional: 00601962 (Belgium, Switzerland, Germany, France, United
Kingdom, Italy, Luxembourg, The Netherlands).
Cascadia

®

is a trademark of Water Pik, Inc. registered in Canada, EU, Switzerland, and the

United States.
Waterpik

®

is a trademark of Water Pik, Inc. registered in Argentina, Australia, Austria, Canada,

China, Czech Republic, Hungary, India, Japan, Poland, Russian Federation, South Africa,
Switzerland, Ukraine, and the United States.
Waterpik

®

(stylized) is a trademark of Water Pik, Inc. registered in Canada, EU, Mexico,

Switzerland, and the United States.
© 2009 Water Pik, Inc.

Water Pik, Inc.

www.waterpik.com

Printed in China

Showerhead made in China

Have any questions or need assistance?

Call our toll-free Customer Service Line:

888-226-3042

8:00 a.m. to 4:00 p.m. MT, Monday-Friday

DATE: 27 May 2009 CLIENT: Water Pik, Inc.
FILENAME: FN20007766-F_AB_CascadiaInst.indd

DESCRIPTION: Cascadia Showerhead Instruction Manual - Canada

FILE TYPE: Adobe InDesign CS4

PREPARED BY: Brian Colon

FORM: 20007766-F AB

SIZE FLAT: 8-1/2” x 8-1/2”

SIZE FOLDED: 3-5/8” x 4-1/4”

FOLDS: Vertical trifold, Horiz bifold

DIELINE: N/A

INK: Black

NOTES:

Advertising