Indicator light, Ice maker – Whirlpool W10326800B Manuel d'utilisation

Page 10

Advertising
background image

10

Door Ajar Alarm (on some models)

The door ajar monitor alarm is located to the left of the
temperature control and sounds an audible alarm if either door is
open for more than 5 minutes.

The alarm is controlled by a three-position switch.

Indicator Light

(on some models)

The indicator light assures you that your freezer is running. If the
indicator light is not glowing, immediately check for:

Power interruption.

An unplugged power cord.

An open circuit breaker or blown fuse.

A burned out indicator light.

Ice Maker

(accessory)

NOTE: The ice maker kit must be purchased separately from your
authorized Whirlpool dealer. Ice maker kit part number is
ECKMF94.

To Turn the Ice Maker On/Off

NOTE: Do not force the wire shutoff arm up or down.

To turn the ice maker on, simply lower the wire shutoff arm.

NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes fill the ice storage bin and the ice cubes
will raise the wire shutoff arm to the OFF (arm up) position.

To manually turn the ice maker off, lift the wire shutoff arm to
the OFF (arm up) position and listen for the click to make sure
the ice maker will not continue to operate.

Shutoff Arm

When installing an ice maker kit, it is necessary to replace the
shutoff arm that is included with the kit, with the longer one
supplied with the freezer.

Portable Ice Bin

The ice bin may be used as a storage container or a portable ice
bucket.
The lid must be open when used as an ice bin.

Close the lid to use as a portable ice bucket or storage container.

Ice Production Rate

The ice maker should produce approximately 7 to 9 batches of ice
in a 24-hour period. If ice is not being made fast enough, turn the
Temperature Control toward a higher (colder) number in half
number steps. (For example, if the control is at 3, move it to
between 3 and 4.) Wait 24 hours and, if necessary, gradually turn
the Temperature Control to the highest setting, waiting 24 hours
between each increase.

Remember

Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.

The quality of your ice will be only as good as the quality of the
water supplied to your ice maker. Avoid connecting the ice
maker to a softened water supply. Water softener chemicals
(such as salt) can damage parts of the ice maker and lead to
poor quality ice. If a softened water supply cannot be avoided,
make sure the water softener is operating properly and is well
maintained.

Do not store anything on top of the ice maker or in the ice
storage bin.

|

The proper setting for normal freezer use.
The alarm is on.

0

The alarm is off.

Tests the alarm.

Advertising