Troubleshooting, Warning, Changing the drum light – Whirlpool Cabrio W10151493B Manuel d'utilisation

Page 23: Dryer operation

Advertising
background image

23

Moving care

For power supply cord-connected dryers:

1. Unplug the power supply cord.

2. Make sure leveling legs are secure in dryer base.

3. Use masking tape to secure dryer door.

For direct-wired dryers:

1. Disconnect power.

2. Disconnect wiring.

3. Make sure leveling legs are secure in dryer base.

4. Use masking tape to secure dryer door.

Changing the Drum Light

The dryer light automatically turns on inside the dryer drum when
you open the door.

To change the drum light

1. Unplug dryer or disconnect power.

2. Open the dryer door. Locate the light bulb cover on the back

wall of the dryer. Remove the screw located in the lower right
corner of the cover. Remove the cover.

3. Turn bulb counterclockwise. Replace the bulb with a 10-watt

appliance bulb only. Replace the cover and secure with the
screw.

4. Plug in dryer or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call...

In U.S.A. www.whirlpool.com/help - In Canada www.whirlpool.ca

Dryer Operation

Dryer will not run

Has a household fuse blown, or has a circuit breaker
tripped?
There may be 2 household fuses or circuit breakers for the
dryer. Check that both fuses are intact and tight, or that both
circuit breakers have not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call an
electrician.

Is the correct power supply available?
Electric dryers require 240-volt power supply. Check with a
qualified electrician.

Was a regular fuse used?
Use a time-delay fuse.

Is the dryer door firmly closed?

Was the Start button firmly pressed?
Large loads may require pressing and holding the Start
button for 2-5 seconds.

No heat

Has a household fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace the
fuse or reset the circuit breaker. If the problem continues, call
an electrician.

Unusual sounds

Has the dryer had a period of non-use?
If the dryer hasn’t been used for a while, there may be a
thumping sound during the first few minutes of operation.

Is a coin, button or paper clip caught between the drum
and front or rear of the dryer?

Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.

Are the four legs installed, and is the dryer level front to
back and side to side?

The dryer may vibrate if not properly installed. See the
Installation Instructions.

Is the clothing knotted or balled up?
When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.

Dryer displaying code message

“PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START to restart the dryer.

“F” Variable (F1, F2, F20, etc.) service codes:
Call for service.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

Advertising
Ce manuel est liée aux produits suivants: