Whirlpool WGD9450WL - Manuel (Page 8)

8
Manual Cycles
Use Manual Cycles to select a specific amount of drying time and
a drying temperature. When a Manual Cycle is selected, the
Estimated Time Remaining display shows the actual time
remaining in your cycle. You can change the actual time in the
cycle by pressing the DRY TIME up or down buttons.
Manual Cycles
Load Type
Temperature Est. Cycle
Time*
(Minutes)
TIMED DRY
Heavyweight items,
bulky items, bedspreads,
work clothes
High 40
TOUCH UP
Helps to smooth out
wrinkles Medium 15
QUICK DRY
Small loads
(On some models - Default)
Medium
High
High
15
15
21
Manual Preset Cycle Settings
*Reset time to complete drying, if needed.
Air Only
Use Timed Dry/Air Only temperature setting for items that require
drying without heat such as rubber, plastic, and heat-sensitive
fabrics. This chart shows examples of items that can be dried
using Air Only.
Type of Load Est.
Time*
(Minutes)
Foam rubber - pillows, padded bras, stuffed toys 20 - 30
Plastic - shower curtains, tablecloths 20 - 30
Rubber-backed rugs 40 - 50
Olefin, polypropylene, sheer nylon 10 - 20
*Reset time to complete drying, if needed.
When using Air Only
■ Check that coverings are securely stitched.
■ Shake and fluff pillows by hand periodically during the cycle.
■ Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Automatic Cycles are not available when using the Air Only
setting.
Steam Cycles
In these cycles, a small amount of water is sprayed into the dryer
drum after several minutes of tumbling with heat. The STEAM
Status Light will come on while the water is sprayed into the drum.
The dryer will continue to tumble at Medium heat for the duration
of the cycle. The Steam Cycles include Quick Refresh and
Enhanced Touch Up. The heat setting and cycle time are not
adjustable for the Quick Refresh Cycle, but can be adjusted for
the Enhanced Touch Up Cycle.
NOTE: Results may vary depending on fabric. 100% cotton
garments with wrinkle-free finish may yield better results than
those without.
Use of a fabric softener sheet is not recommended with steam
cycles as it may cause temporary staining on the clothes.
Steam Preset Cycle Settings
Timed Cycles
Load Type
Default
Temperature*
Est. Time*
(Minutes)
QUICK REFRESH
Helps to smooth out
wrinkles and reduce odors
from loads consisting of
one to four dry items.
Medium 15
ENHANCED TOUCH UP
Helps to smooth out
wrinkles in loads left in the
dryer for an extended
period.
Medium 20
*The Enhanced Touch Up Cycle has a minimum dry time of
15 minutes and a maximum dry time of 40 minutes. Only the
Medium and High temperature settings can be used for the
Enhanced Touch Up Cycle.
Additional Features
Drum Light
When pressed during a cycle, the Drum Light turns on and will
remain on until pressed again, the door is opened and closed, or
the door is left open for 20 minutes.
WRINKLE SHIELD™ Feature
When you are unable to remove a load of clothes from the dryer
as soon as it stops, wrinkles can form. The WRINKLE SHIELD™
feature periodically tumbles, rearranges, and fluffs the load to help
keep wrinkles from forming.
■ Get up to 140 minutes of heat-free, periodic tumbling at the
end of a cycle. Turn off at any time by pressing the WRINKLE
SHIELD™ feature or opening the dryer door.
■ For the Casual Cycle, the WRINKLE SHIELD™ feature is
preset to “ON.” The other cycles will retain the WRINKLE
SHIELD™ feature setting. (The Wrinkle Shield feature is preset
to “ON” for the Casual Cycle. If selected for other cycles, it will
remain “ON” the next time that cycle is selected.)