Warning, Complete installation – Whirlpool Cabrio W10150626A Manuel d'utilisation

Page 13

Advertising
background image

13

4. Install the 2 hinges to the front panel of the dryer using

4 screws. Use the non-slotted side to attach the hinge to the
front panel.

5. Install screws in the top hinge holes in the door. Do not

tighten screws. Leave approximately ¼" (5 mm) of screw
exposed.

6. Hang door by placing screw heads into top slotted holes of

hinges and slide door down. Align bottom screw holes in
hinge and door. Install two bottom screws. Tighten all hinge
screws.

7. Close door to engage door strike.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer’s final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See “Level Dryer.”

6. Plug into a grounded 3 prong outlet. Turn on power.

7. Remove any protective film or tape remaining on the dryer.

NOTE: Glass door models have a protective film on the
window that should be removed.

8. Read “Dryer Use.”

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Test dryer operation by selecting a Timed Dry heated cycle

and starting the dryer. For this test, do not select the Air Only
modifier.

If the dryer will not start, check the following:

Dryer is plugged into a grounded 3 prong outlet.

Electrical supply is connected.

Household fuse is intact and tight, or circuit breaker has
not tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and
close door. If you do not feel heat, turn off the dryer and
check that the gas supply line shutoff valve is open.

If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.

If the gas supply line shutoff valve is open, contact a
qualified technician.

A. Install these screws first.

A

A

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

Advertising
Ce manuel est liée aux produits suivants: