Whirlpool GERC4110PB0 - Manuel (Page 11)

11
Start
Style 1 - Electronic Oven Control
The Start pad begins any oven function. The display will show
SET TEMP OR TIME OR PUSH START.
Styles 2 & 3 - Electronic Oven Controls
The Start pad begins any oven function. If not pressed within
5 seconds after pressing a function pad, the “START?” or “?”
indicator light will appear on the display (on some models).
If the Start pad is not pressed within 5 minutes after pressing a
function pad, the oven display will return to the time of day mode
and the programmed function will be canceled.
Off/Cancel
The Off/Cancel pad stops any function except the Clock setting,
Timer, Control Lock or Warm Drawer (on some models).
Clock
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK. SET CLOCK TIME will appear on the display.
2. Depending on your model, press the HR or MIN or TIME/
TEMP “up” or “down” arrow pads to set the time of day,
including a.m. or p.m.
3. Press any key other than Off/Cancel.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid pad press
■ Oven is preheating (long tone)
■ Function has been entered
■ Reminder (on some models), repeating each minute after the
end-of-cycle tones
Three tones
■ Invalid pad press
Four tones
■ End of cycle
Style 1 - Electronic Oven Control
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold BAKE for 5 seconds. REMINDER TONES
OFF will appear on the display. Repeat to turn reminder tones
back on, and REMINDER TONES ON will appear on the display.
All Tones: All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.
To disable tones, press and hold CLOCK for 5 seconds. Repeat
to turn tones back on.
To Turn Off/On: Press and hold CLOCK for 5 seconds. A tone
will sound when changing tones from OFF to ON. ALL SOUNDS
OFF will appear on the display. Repeat to turn tones on, and ALL
SOUNDS ON will appear on the display.
Tone Pitch: The pitch is preset at high, but can be changed to
low.
To Change: Press and hold BROIL for 5 seconds. A tone will
sound, and TONE PITCH LOW will appear on the display. Repeat
to change and TONE PITCH HIGH will appear on display.
End of Cycle Tones: Press and hold CONVECT for 5 seconds to
turn END OF CYCLE TONES off. Press and hold CONVECT for
5 seconds to turn END OF CYCLE TONES on.
Key Press Tone: Press and hold WARM (Cooking Options) for
5 seconds, and KEY PRESS TONES OFF will appear on the
display. Press and hold WARM for 5 seconds, and KEY PRESS
TONES ON will appear on the display.
Style 2 - Electronic Oven Control
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold TIMER SET for 5 seconds. “rEP OFF” or
“OFF” will appear in the display. Repeat to turn reminder tones
back on, and “rEP ON” or “ON” will appear in the display.
All Tones: All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.
To Turn Off/On: Press and hold STOP TIME for 5 seconds. A
tone will sound, and “Snd OFF” will appear on the display. Press
and hold COOK TIME for 5 seconds to turn tones on, and “Snd
ON” will appear on the display.
Tone Pitch: The pitch is preset at high, but can be changed to
low.
To Change: Press and hold DELAY START for 5 seconds. A tone
will sound, and “Snd LO” will appear on the display. Repeat to
change, and “Snd HI” will appear on display.
Style 3 - Electronic Oven Display
Refer to basic functions for Tones.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
Style 1 - Electronic Oven Control
To change: Press and hold AUTO CLEAN for 5 seconds, and
TEMPERATURE UNIT CELSIUS will appear in the display. Repeat
to change back to Fahrenheit.
To exit mode, press OFF/CANCEL.
Styles 2 & 3 - Electronic Oven Controls
To change: Press and hold BROIL for 5 seconds. Repeat to
change back to Fahrenheit.
To exit mode, press OFF/CANCEL.