Panasonic CF-35 - Manuel (Page 25)

25
A port replicator is available as an option (CF-VEB351). This device eliminates the hassles of
having you connect/disconnect the various cables when carrying your computer around and
allows a variety of peripherals to be connected including a headphone or microphone, etc.
The port replicator connects to the expansion bus connector on the bottom of your computer.
When your computer is not connected to the port replicator, be sure that the expansion bus
connector on the bottom of the computer is covered.
For more detailed information, please refer to the operation manual for the port replicator.
Connecting a Port Replicator
NOTE
Some printer cables may be difficult to connect, and may require removal of the rear
cover. Take care not to lose the cover.
2
1
Connect the printer to your computer
CAUTION
Do not install or remove peripherals while your computer is in the suspend or hiber-
nation mode; abnormal operation may result.
Do not shut down using the suspend or hibernation mode.
Power off your computer ( page 10)
Turn on the printer, then turn on your computer
3
Using a Printer
1
CAUTION
Do not install or remove peripherals while your computer is in the suspend or hiber-
nation mode; abnormal operation may result.
2
Connect the external display to your computer
Do not shut down using the suspend or hibernation mode.
Power off your computer ( page 10)
NOTE
For more detailed information, please refer to the operation manual for the external
display.
Run the Setup Utility ( page 36).
Using and , select [Display], set [Simultaneous] with
then press
Using and , select [System Setup] then press
Close the Setup Utility ( page 36).
Turn on the display, then turn on your computer
3
To display on both the LCD of your computer and the external
display
Using an External Display
Parallel Port
Ext. Display Port
1
2
3
4
5
Select your external display
Set your external display for [Models] in [Start] - [Settings] - [Control Panel] -
[Display] - [Settings] - [Advanced Properties] - [Monitor] - [Change] - [Show all
devices], then press .