Panasonic TC 26LX50 - Manuel (Page 6)

6
Remote control battery installation
1. Open the battery cover. 3. Replace the cover.
Requires two AA batteries.
Two AA size
Notes:
• Do not drop, apply shock to or step on the remote control.
• Do not spill water on the remote control.
• Do not place objects between the remote control and remote control receiver.
• Do not use remote controls for other equipment at the same time.
• If the TV does not operate even when using the remote control from a close range, it is time to replace
the batteries.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environmentally friendly manner.
1. Always use new batteries when replacing the old set.
2. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3. Battery replacement is necessary when remote control acts sporadically or fails to operate this unit.
2. Install the batteries.
Note the correct polarity (+ and -).
SUPPLIED ACCESSORIES
Place the TV face down
on a foam mat or a thick
soft cloth to prevent
damage to the panel.
Foam mat or thick soft
cloth
1 Carefully pull out the TV-Stand.
Reinstall the cable cover.
(see page 7)
4
3
2
Follow the procedure below when the TV-Stand needs to be removed for wall-hanging.
5
Remove the cable cover. (see page 7)
Remove screws. (at 4 points)
How to remove the TV-Stand