Panasonic AJ-B95 - Manuel (Page 65)

65
Voice-over operations (2)
1
Select “INT_VO” as the setup menu item No.317
(AUD MEM MODE) setting.
“m” now appears on the superimposed display
of VTR2. (See page 85)
2
Select the channel (CH1, CH2) on which the
sound is to be recorded with the setup menu
item No.318 (AUD MEM CH) setting.
3
Connect the audio signals which are to be
recorded.
When connecting a microphone, connect it to
CH2 on the VTR2 side (the second AUDIO IN
connector from the left as seen from the rear
panel).
4
Set the VTR2 AUDIO INPUT selector switch
(ANALOG/SDI/INT) for the channel on which the
sound is to be recorded to the ANALOG
position.
5
Set the VTR2 AUDIO INPUT selector switch
(channel selector) for the channel on which the
sound is to be recorded to the audio signal input
channel.
6
Insert the voice-over cassette tape into VTR2.
7
Press the insert buttons (A1, A2) for the channel
on which the sound is to be recorded to turn on
their lamps.
8
Set the IN point and OUT point of the voice-over
positions.
9
Press the PREVIEW button to execute preview.
10
Input the sound to be recorded (from the
microphone, etc.) between the IN point and OUT
point during preview.
The input sound is now stored in the internal
memory.
Twenty seconds after this information is written
into the internal memory, “o” appears on the
superimposed display to indicate that the
memory is now full. (See page 85)
11
Press the AUTO EDIT button to execute editing.
The sound stored in the memory is now
recorded on the tape.
Voice-over can also be performed by taking the steps
below.
Steps
1
through
7
are the same as for voice-over
operations (1).