Panasonic AJ-B95 - Manuel (Page 61)

61
Editing without setting the edit IN point (park & edit)
Editing can be performed without setting the VTR1
and VTR2 IN points.
1
Operate VTR1 and VTR2, and locate the places
which will serve as the IN points.
2
Press the PREVIEW button.
The position where the PREVIEW button was
pressed is automatically set as the edit IN point,
and preview is executed.
When the OUT points have not been set either,
press the MARK OUT button during the preview at
the place which is to serve as the OUT point.
The position where the MARK OUT button was
pressed is automatically set as the edit OUT point.
<Note>
To proceed with editing while skipping the preview,
press the AUTO EDIT button in step
2
instead of the
PREVIEW button, and proceed with editing.
The position where the AUTO EDIT button was
pressed is automatically set as the IN point, and
editing is executed.
3
Press the AUTO EDIT button to proceed with
editing.
Editing using the edit IN point setting only (open-ended editing)
1
Set the VTR1 and VTR2 IN points.
2
Press the PREVIEW button to proceed with
preview.
3
During the preview, press the MARK OUT button
at the place which will serve as the OUT point.
<Note>
To proceed with editing while skipping the preview,
press the AUTO EDIT button in step
2
instead of the
PREVIEW button, and proceed with editing.
Press the AUTO EDIT button or the MARK OUT
button at the position where editing is to be ended.
The position where the button was pressed is
registered as the OUT point.
Auto tag editing
With this editing function, the registered edit OUT
point is automatically set as the edit IN point of the
next editing session (next event).
This enables continuous editing from one event to the
next without the need to set the IN points.
This function comes in handy for same position
editing.
1
Select REC1, REC2 or ALL as the setup menu
item No.313 (AUTO ENTRY) setting.
(This selects the VTR whose IN point is to be
automatically set.)
2
Proceed with automatic editing.
3
When the editing of one event is completed and it
carries over to the next event, the IN point of the
VTR selected in step
1
has already been set so
that the remaining edit points are set, and the next
event is edited.