Panasonic UF-885 - Manuel (Page 61)

59
Redialing
Automatic Redialing
Manual Redialing
You can also redial the last dialed number manually by pressing key.
To redial the last dialed number through memory
To redial the last dialed number through ADF
(see Note 1)
If a busy line is detected, the machine will redial the number up
to 5 times at 3 minutes interval. However, if a busy line is not
detected, the machine will redial only one time. During that time,
a message will appear as shown to the right.
A file number is shown in the upper right hand corner of the
display if it is a memory transmission file.
1
Set document(s) face down.
Make sure that the MEMORY lamp is on.
2
3
The document is stored into memory with a file number.
Then dials the last dialed number.
1
Set document(s) face down.
2
Make sure that the lamp goes off.
3
Your machine starts to dial the last dialed number.
1. While the unit is displaying "WAIT TO DIAL", you can press to start redialing immediately.
WAIT TO DIAL NO.001
(Telephone number)
REDIAL
ENTER STATION(S)
THEN PRESS START 00%
PAUSE
REDIAL
TEL. NO.
5551234
START
* STORE * NO.002
PAGES=001 01%
* DIALING * NO.002
5551234
ENTER STATION(S)
THEN PRESS START 00%
MEMORY
ENTER STATION
00%
PAUSE
REDIAL
START
PRESS START TO DIAL
5551234
* DIALING *
5551234
REDIAL
Sending Documents
Note:
4