Replacement of parts – Panasonic NC-HU301P Manuel d'utilisation

Page 23

Advertising
background image

23

Mesh filter

If the problem cannot be resolved, or if you think something is still wrong with the unit, disconnect

the plug, reconnect after 30 seconds and operate it again.

Inside lid may turn yellow, but operation will not be affected.

“Clickety-clack” sound caused when open and close the lid is the sound caused by the valve

swing to prevent the hot water run off.

Outside body becomes 113°F(45°C) while warm keep if the room temperature is high.

The unit doesn’t

turn on .

If the electric components

get wet, the unit must

be repaired. Contact the

store where you purchased

the unit for repair.

You poured in water directly from a tap.

You put the unit on the sink.

You turned the unit upside down with

its bottom wet.

You washed the unit in water.

Replacement of Parts

Replacement of Parts

Replace gaskets if they crack, lose their pliancy

or, for any other reasons which allow steam to

escape from between the container and the lid.

Replace the filter if foreign materials which

clog the filter cannot be removed even after

you scrub with a cleaning brush, etc.

Lid cover

Set gaskets

Consumable parts are available from an

authorized dealer.

Part name

Part No.

Rubber gasket set

APH65-613-0S

Mesh filter

APB97-480-0U

Remove lid, unscrew 3 tapping screws and

remove the lid cover.

Exchange the gaskets and then place the lid

cover back and secure with the tapping screws.

The indicator lights flash

alternately and displays

.

This is a malfunction of the sensor. Contact the retailer where you

purchased the unit.

Rubber gasket set

NC-HU401_301-EN-6.indd 23

11/12/08 2:35:59 PM

Advertising
Ce manuel est liée aux produits suivants: