64 – english, Edge blending adjustment, Press ◄► to adjust. 3 – Panasonic PT-DW100U Manuel d'utilisation

Page 64: Press ▲▼ to select “edge 1. blending, Press ◄► to switch “edge 2. blending, Press enter. 3, Press ▲▼ to specify the area to 4. be adjusted, Marker press ▲▼ to select “marker”. 7, Press ◄► to select “on”. 8, Press ▲▼ to select “bright 9. adjust

Advertising
background image

64

ENGLISH

How to use ADVANCED MENU (continued)

Press ENTER.

2.

The “CLAMP POSITION” screen will be

displayed.

CLAMP POSITION
POSITION

ADJUST

1

Press

◄► to adjust.

3.

The value changes from 0 to 255.

The optimal value for the clamp position

adjustment
If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.

Note

The clamp position can be adjusted only when the

RGB signal input is applied with RGB1 and RGB2 IN.

Edge blending adjustment

The built-in edge blending feature allows multiple
projector images to be seamlessly overlapped.

Press

▲▼ to select “EDGE

1.

BLENDING”.

CLAMP POSITION

EDGE BLENDING

FRAME DELAY

OFF

DEFAULT

Press

◄► to switch “EDGE

2.

BLENDING”.

The setting will change as follows each time

◄► is pressed.

OFF

ON

USER

OFF:

When the multi-screens are not going to be used.

ON:

When the default linear blending ramps are
sufficient.

USER:

When a user-defined blending ramp is required.
These ramps can be defined and uploaded to the
projector through the RS-232 port. Consult your
dealer for details.

Press ENTER.

3.

The “EDGE BLENDING” screen will be

displayed.

EDGE BLENDING
UPPER

START

ON

0

Press

▲▼ to specify the area to

4.

be adjusted.

To blend the top edge:

set “UPPER” to “ON”.

To blend he bottom edge:

set “LOWER” to “ON”.

To blend the left edge:

set “LEFT” to “ON”.

To blend the right edge:

set “RIGHT” to “ON”.

Press

◄► to toggle “ON” and

5.

“OFF”.

Press

◄► to adjust the overlap

6.

width and the starting point.

To display the adjustment

„

marker

Press

▲▼ to select “MARKER”.

7.

RIGHT

MARKER

BRIGHT ADJUST

OFF
OFF

Press

◄► to select “ON”.

8.

A marker for adjusting the overlap position

appears. The optimal point is the position
where the red line of one frame overlaps the
green line of the other frame.
The blending widths of each projector must be
set to the same value. Optimal blending cannot
be achieved if the widths are different.

The optimal point is where

these lines overlap.

Green line

Red line

Press

▲▼ to select “BRIGHT

9.

ADJUST”.

RIGHT
MARKER

BRIGHT ADJUST

OFF
OFF

Advertising