54 – english, Gamma setting, Press ▲▼ to select “gamma”. 1 – Panasonic PT-DW100U Manuel d'utilisation

Page 54: Press ◄► or enter. 2, Press ◄► to switch “gamma”. 3

Advertising
background image

54

ENGLISH

Adjusting the picture (continued)

Press

◄► to switch “COLOR

3.

TEMPERATURE”.

The setting will change as follows each time

◄► is pressed.

DEFAULT

HIGH

USER1

MIDDLE

USER2

LOW

When any setting other than “OFF” has been

selected for color matching, the COLOR
TEMPERATURE setting is fixed at “USER1”.

“DEFAULT” cannot be selected when the picture

mode has been set to “USER”.

To further adjust toward the

„

desired white balance
Select “USER1” or “USER2” in

4.

Step 3.

Press ENTER.

5.

The “WHITE BALANCE” screen will be

displayed.

WHITE BALANCE
WHITE BALANCE HIGH

WHITE BALANCE LOW

Press

▲▼ to select “WHITE

6.

BALANCE HIGH” or “WHITE
BALANCE LOW”.

Press ENTER.

7.

The “WHITE BALANCE HIGH” RGB settings

are used to set the projector’s white point color
temperature. The “WHITE BALANCE LOW”
RGB settings are used to adjust the color
temperature of the black levels.

WHITE BALANCE HIGH
RED

GREEN

255
255

Press

▲▼ to select “RED”,

8.

“GREEN” or “BLUE”.

Press

◄► to adjust the level.

9.

Item

Operation

Adjustment

Adjustment

range

RED

Press ►
button.

Deepens red.

Maximum

value

HIGH : 255

LOW : 127

Minimum

value

HIGH : 0

LOW : -127

Default

HIGH : 255

LOW : 0

Press ◄
button.

Weakens red.

GREEN

Press ►
button.

Deepens green.

Press ◄
button.

Weakens green.

BLUE

Press ►
button.

Deepens blue.

Press ◄
button.

Weakens blue.

Note

All colors will not be displayed properly unless

adequate adjustment is made. If the adjustment
does not look suitable, you can press DEFAULT to
return the setting for the selected item only to the
factory default setting.

The color temperature cannot be adjusted for the

internal test pattern (p. 85). Be sure to project the
input signal when adjusting the color temperature.

Gamma setting

This switches the gamma mode.

Press

▲▼ to select “GAMMA”.

1.

COLOR

TEMPERATURE

GAMMA

SHARPNESS

DEFAULT
DEFAULT

0

Press

◄► or ENTER.

2.

The “GAMMA” individual adjustment screen

will be displayed.

GAMMA

CHANGE

DEFAULT

Press

◄► to switch “GAMMA”.

3.

The setting will change as follows each time

◄► is pressed.

DEFAULT

2.6

USER1*

2.5

USER2*

2.2

* “USER1” and “USER2” can hold user-defined

gamma curves uploaded to the projector through
the RS-232 terminal.
Additional Gamma settings can be made available
for selection from a sub-menu.
Consult your dealer for more information.

Note

“DEFAULT” cannot be selected when the picture

mode has been set to “USER”.

Advertising