Electrical connections – Panasonic CQ-C1200U Manuel d'utilisation

Page 16

Advertising
background image

(+)

(–)

(+)

(–)

(+)

(–)

(+)

(–)

FRONT SP

REAR SP

ACC

BATTERY 15A

1

3

2

S

W-OUT

19

E
N

G

L

I

S
H

20

E
N

G

L

I

S
H

31

30

CQ-C1200U/C1120U/C1110U/C1100U

CQ-C1200U/C1120U/C1110U/C1100U

Electrical Connections

Cautions:
• This product is designed to operate with a 12 V DC, negative ground battery system.
• To prevent damage to the unit, be sure to follow the connection diagram below.
• Strip about 5 mm of the lead ends for connection.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables

and keep cable terminals free from touching any metal parts.

• Remember, if your car has a drive computer or a navigation computer, the data of its memory may be

erased when the battery terminals are disconnected.

External Power Amplifier
CY-M7052
(option)

RCA Cord (option)

RCA Cord (option)

Sub-Woofer
cord
(monaoural)

CQ-C1200U/C1120U
CQ-C1110U/C1100U

Sub-Woofer
(option)

Ground lead
To a clean, bare metallic part of car chassis.

Battery lead
To the car battery, continuous +12 V DC

Power lead
To ACC power, +12 V DC

Note: This lead is used for power control
when an external power amplifier is con-
nected. The power supply of a power
amplifier will be activated when turning
on the power of this unit.

Amp. relay control power lead
(Max. 500 mA)
This lead is for connection to the power
amplifier.

Note: The power antenna extends automatically
when the FM/AM radio mode is selected.

Motor antenna relay control lead
(To motor antenna) (Max. 500 mA)
This lead is not intended for use with switch
actuated power antenna.

(Black)

(Yellow)

Antenna

(R) Red

(L) White

y Power connector

Fuse (15 A)

C

(Red)

(Dark blue/white stripe)

(Dark blue)

y
Power
connector

Fuse

To remove
the Fuse

Only for CQ-C1200U

Only for CQ-C1200U/C1120U/C1110U

External Power Amplifier
CY-M9054
(option)

Speaker lead

System up
speakers

(White/
black
stripe)

Left speaker

(Front)

Right speaker

(Front)

Left speaker

(Rear)

Right speaker

(Rear)

(White)

(Gray/black
stripe)

(Gray)

(Green/black
stripe)

(Green)

(Violet/
black
stripe)

(Violet)

C

If the fuse (rear panel) blows fre-
quently, they may be something
wrong with the unit or wiring. Consult
your nearest Panasonic Servicenter
for service.

(L) White

(R) Red

Speaker connections

• Do not connect more than one speaker to one set of speaker leads (except for

connecting to a tweeter).

• Do not use a 3-wire type speaker system having a common earth lead.

L

R

L

R

Preamp. output connector (rear)

Preamp. output connector (front)

Note: A bridge connection should be
used when connecting only 2 channels
such as CQ-C1100U connection.

Advertising
Ce manuel est liée aux produits suivants: