Replacing the lamp unit, Check the lamp unit replacement time, Care and replacement – Panasonic TQBJ0302 Manuel d'utilisation

Page 48: Nglish, Air filter, Lamp unit, Lamp unit replacement time

Advertising
background image

Care and Replacement

Maintenance

48 -

E

NGLISH

Replacing the Lamp unit

Air filter

J

The air filter should be replaced when cleaning is ineffective and when replacing the lamp unit. A replacement

air filter is provided with a replacement lamp unit (ET-LAB80). Contact an Authorized Service Center for the

optional air filter (TXFMZ01VKG7).

Lamp unit

J

The lamp unit, ET-LAB80 is consumable and you must replace it regularly. It is recommended that a qualified

technician carry the lamp unit replacement and consult with an Authorized Service Center.

J

Note on lamp unit replacement

Handle the lamp unit with special care as it is a glass

z

product. Dropping or giving it a shock may cause it

to burst or to be damaged.

If you wish to discard the used lamp, please contact

z

your local authorities or dealer and ask for the

correct method of disposal.

Prepare a Phillips-head screwdriver.

z

When replacing the lamp unit, be sure to hold it by

z

the handle.

Hold the lamp unit horizontally to prevent broken

z

pieces from scattering. When the projector is

mounted in the ceiling, do not work directly under the

projector or put your face close to the projector, and pull out the lamp

horizontally.

Note

Prior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.

z

Remarks

Do not attempt replacement with an unauthorized lamp unit.

z

Lamp unit replacement time

J

When the lamp is consumed, the brightness may decrease over time. 3 000 hours of use is the replacing

time as a rough guide, and that might be shortened by the usage conditions, characteristics of the lamp unit

or environmental conditions. You can find the duration of usage time by checking

LAMP RUNTIME in the

PROJECTOR SETUP menu. Do not use a lamp unit over 3 000 hours. Failure to observe this may result in

explosion of the lamp.

ON-SCREEN DISPLAY

REPLACE LAMP

LAMP indicator

2 800 hours

Displays “

REPLACE LAMP” on the upper left of the screen

for 30 seconds. If any button is pressed within 30 seconds,

the message disappears.

Illuminates red, even in the

standby mode.

3 000 hours

Displays “

REPLACE LAMP” on the upper left of the screen,

and it will stay until you respond. The power is turned off

automatically in 10 minutes.

Remarks

The guide time, 3 000 hours, is a rough estimate based on certain conditions and is not a guaranteed time.

z

Advertising