Panasonic TQBJ0302 - Manuel (Page 44)

SECURITY menu
Settings
44 -
E
NGLISH
MENU LOCK
Press the MENU button to display the menu. You can
lock or unlock the menu operation.
Change setting Change setting
OFF Unlock the menu operation
ON Lock the menu operation
Remarks
Once z MENU LOCK is set to ON, you cannot use
the MENU button unless you input the correct
password.
The z MENU LOCK is set to OFF by default and
when initialised.
MENU LOCK PASSWORD
When MENU LOCK is set to ON, you can set a
MENU LOCK PASSWORD.
Press▲▼◄►buttons to select the 1 )
required character and press the
ENTER button.
(You can input up to 16 characters.)
To delete all the entered characters, move the
cursor to ALL DELETE and press the ENTER
button. To delete a character, press the DEFAULT
button or move the cursor to the required
character then press the DEFAULT button.
ALL DELETE
OK CANCEL
MENU LOCK PASSWORD
SPACE
Press▲▼◄►buttons to select OK and 2 )
press the ENTER button.
Select CANCEL or press the MENU/RETURN
button to return to the previous menu without
setting.
Remarks
When using the projector for the first time or after z
INITIALIZE ALL operation is activated, the initial
password is set as AAAA.
Change your password regularly. Do not use a z
simple password that is too easy to guess.
To reset the password to the initial password, see z
“MENU LOCK PASSWORD” ( Æ page 54).
CONTROL DEVICE SETUP
You can enable/disable the button operations of the
control panel and remote control.
Change setting Change setting
J
CONTROL PANEL
ENABLE Enable the button operations
DISABLE Disable the button operations
REMOTE CONTROLLER
J
ENABLE Enable the button operations
DISABLE Disable the button operations
Remarks
If z DISABLE is set, the confirmation screen appears.
Select OK and press the ENTER button.
If any button is pressed when z DISABLE is set, the
password screen appears.
Input the password which is set in the SECURITY
menu.
The z PASSWORD screen will be displayed for 10
seconds.
If you set both z CONTROL PANEL and REMOTE
CONTROLLER to DISABLE, all the button
operations of the control panel and remote control
are disabled and you cannot turn off the power.
In the standby mode, press and hold the z ENTER
button of the control panel and MENU button for at
least 2 seconds. The buttons on the control panel
are enabled.
You can also enable the button operation by
pressing and holding the ENTER button of the
control panel and MENU button for at least 2
seconds while the projector is projecting.