Panasonic TQBJ0302 - Manuel (Page 39)

PROJECTOR SETUP menu
Settings
E
NGLISH - 39
PROJECTOR SETUP menu
Navigating through the MENU ( Æ page 27), select
PROJECTOR SETUP from the main menu and
then select the required item from the sub-menu.
Set the selected item with◄►buttons. z
Remote control Control panel
STATUS
You can check the using status of the projector.
SIGNAL
J
NAME: Name of input signal z
FREQUENCY: Scanning frequency of input z
signal
RUNTIME
J
PROJECTOR: Display current usage time of z
projector
LAMP: Display current usage time of lamp z
NO SIGNAL SHUT-OFF
If no image signal is input for the time set with the
timer, the projector will enter into standby mode
automatically.
Change setting Change setting
DISABLE NO SIGNAL SHUT-OFF is disabled
15 - 60 MIN. Timer can be set in intervals of 5
minutes
INITIAL START UP
You can set the starting method when the power plug
is connected to wall outlet.
Change setting Change setting
LAST MEMORY
Projector starts from the last image
before the power plug was
disconnected
STANDBY
Projector starts in the standby
mode
ON Projector starts immediately
INSTALLATION
When installing the projector, select the projection
method according to the projector position.
( Æ page 16)
Change setting Change setting
FRONT/
DESK
Setting on a desk/floor and
projecting from front
FRONT/
CEILING
Mounting in the ceiling with a ceiling
mount bracket (sold separately) and
projecting from front
REAR/DESK
Setting on a desk/floor and projecting
from rear (Translucent screen is
required)
REAR/CEILING
Mounting in the ceiling with a ceiling
mount bracket (sold separately) and
projecting from rear (Translucent
screen is required)
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the
fan speed high.
Change setting Change setting
OFF For use in normal environment
ON For use at high altitude
Remarks
At 1 400 -2 700 m (4 593 - 8 858 ft) sea level, the z
setting must be ON.
The loudness of fan noise depends on the z HIGH
ALTITUDE MODE setting.