Lamp runtime, Power off timer, Direct power on – Panasonic PT-LB51SU Manuel d'utilisation

Page 35: Control panel, Auto setup, Signal search, Installation, See “signal, Power off timer direct power on, Nglish - 35

Advertising
background image

OPTION menu

E

NGLISH - 35

Settings

You can check how long the lamp has been used.

You can set the off timer to switch off the POWER of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.

You can switch the projector start up status for when the
Power cord

is connected. Press I H to select the

required option.

OFF

The projector will start from the
standby mode or the projecting
mode.
(The projector will start from the
same status as when the power cord
was disconnected.)

ON

The projector will start from the
projecting mode.

You can turn off the function of the control panel buttons
on the projector body. Press I H to select the required
option.

INVALID

Invalidate the control panel buttons
Confirmation screen will be
displayed.

VALID

Validate the control panel buttons

You can turn off the AUTO SETUP function for when the
COMPUTER

signal is detected.

AUTO

When the projector detect a
COMPUTER

signal, adjust the

projected image position
automatically for SIGNAL SEARCH,
DOT CLOCK

and CLOCK PHASE.

BUTTON

Only when the AUTO SETUP button
is pressed, the projected image
position will be adjusted for DOT
CLOCK

and CLOCK PHASE. See

“Remote control” on page 10.

You can turn off the auto signal detecting system.

ON

Detect the input signal from the
terminals and project the image.

OFF

Deactive

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See “Projection method” on
page 16.

LAMP RUNTIME

NOTE:

LAMP RUNTIME is a relevant matter for lamp

replacement timing. See “Replacing the Lamp unit” on
page 41.

POWER OFF TIMER

DIRECT POWER ON

NOTE:

• When the projector is started from the projecting mode,

pressing the POWER button procedure is skippable.

CONTROL PANEL

DISABLE

15 MIN.

20 MIN.

25 MIN.

30 MIN.

35 MIN.

60 MIN.

55 MIN.

50 MIN.

45 MIN.

40 MIN.

AUTO SETUP

NOTE:

• Usually the recommended setting is AUTO.

SIGNAL SEARCH

NOTE:

SIGNAL SEARCH is not available when any input

signal is projecting.

• Usually the recommended setting is ON.

INSTALLATION

FRONT/DESK

Setting on a desk/floor and
projecting from front

FRONT/CEILING

Mounting in the ceiling and
projecting from front

REAR/DESK

Setting on a desk/floor and
projecting from rear

REAR/CEILING

Mounting in the ceiling and
projecting from rear

Advertising