15 setting projector id number to remote control, Connect to the projector to use with a cable – Panasonic PT-D4000U Manuel d'utilisation

Page 15

Advertising
background image

15

Setting projector ID number to remote control

Every projector has its ID number and the ID number of the controlling projector must be set to the remote
control in advance so that the user can operate the remote control. The ID number of the projector is set to
“ALL” on shipping, and use the ID ALL button of the remote control when using only a single projector.

Procedure of ID setting

Press the ID SET button, and within five seconds use the number (0 to 9) buttons
to enter the 2-digit ID number set by the projector.

However, if the ID ALL button is pressed, the projector can be controlled regardless of the ID number of the
projector (simultaneous control mode).

• Do not press the ID SET button accidentally or carelessly because the ID number on the remote

control can be set even when no projector is around.
If the ID SET button is pressed, the ID number goes back to the one set before pressing the ID
SET button unless a numeric button is pressed within five seconds after the ID SET button is
pressed.

• Your specified ID number is stored in the remote control unit unless another one is specified later.

However, the stored ID will be erased if the batteries of the remote control are left exhausted.
When the dry cells are replaced, set the same ID number again.

Attention

Connect to the projector to use with a cable

When multiple main units are connected in the system, connect the units with the M3 stereo mini jack cable
available in the market to simultaneously control the multiple main units with a single remote control unit through
the REMOTE1 IN/OUT terminal. It is effective to use the wired remote control in the environment in which an
obstacle stands in the light path or where devices are susceptible to outside light.

• Use two-core shielded cable of length smaller than 15 m (49.2'). If the cable length exceeds 15 m

(49.2'), or if the shielding of the cable is inadequate, the operation may be unsatisfactory.

Attention

B/P

B

G/Y

R

R/P

REMOTE 1

REMOTE 2 IN

RGB 1 IN

VIDEO IN

S-VIDEO IN

IN

OUT

Connect to the
secondary projector

M3 stereo mini jack cable
(available in the market)

Advertising