Reinstalling software – Panasonic CF-T4 Manuel d'utilisation

Page 42

Advertising
background image

Reinstalling Software

42

Troubleshooting

z

If you press the 2 key the reinstallation will be canceled.

C

Make a selection from the menu.
z

To return the computer to its status at the time of purchase
Press the 1 key.

z

To divide the hard disk into two partitions (for OS and data)
Press the 2 key.

Enter the basic partition size (GB) for the operating system installation
and press the Enter key.
• You can cancel this operation by pressing the 0 key.
• The data partition size is the remainder after subtracting the basic

partition size. (Data partition: 1 GB or more)
Maximum settable size differs depending on the model.

z

To reinstall Windows in the first partition without changing the partition
configuration
Press the 3 key.
• The first partition size must be 6 GB or more of the hard disk size.

Reinstallation cannot be performed with a small partition size.

<When the hard disk backup function has been enabled>
If you select [1] or [2], the message [The Backup function has been enabled.
If [Recovery] is executed, the Backup function will be disabled, and your
Backup data will be lost.] appears. In this case, press the Y key.
If the message [Computer must be rebooted in order to execute [Recovery]]
appears, press the R key.
D

At the confirmation message, press the Y key.
z

The operation of reinstallation for the hard disk starts automatically.
(The operations take about 20 minutes.)

z

Do not interrupt the reinstallation procedure before completion, for
example by turning off the computer or pressing the Ctrl + Alt + Del
key, as this may prevent Windows from starting up, or may cause data
to be lost so that the reinstallation procedure cannot be executed.

E

The message "[Recovery] is complete" will be displayed. Remove the Prod-
uct Recovery DVD-ROM, and press any key to shut down the computer,
then remove the DVD-ROM & CD-R/RW drive.

4

Return the Setup Utility settings to their default values.

Return the Setup Utility to its settings at the time of purchase to ensure
proper setup of Windows.
A

Turn on the computer, and press the F2 key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password, and press
the Enter key.

B

Press the F9 key.
At the confirmation message, select [Yes] and press the Enter key.

C

Press the F10 key.
At the confirmation message, select [Yes] and press the Enter key.
The Setup Utility will close, and the computer will restart.

Advertising