Panasonic CF-T4 - Manuel (Page 41)

41
Troubleshooting
1
Turn off the computer and connect the DVD-ROM & CD-R/
RW drive to the computer, then connect the AC adaptor.
Do not interrupt the reinstallation procedure before completion, for example
by turning off the computer or pressing the Ctrl + Alt + Del key, as this
may prevent Windows from starting up, or may cause data to be lost so that
the reinstallation procedure cannot be executed.
2
Change the settings in the Setup Utility.
Make the following settings.
z
Return settings to the status at the time of purchase.
z Change settings to enable startup from DVD-ROM & CD-R/RW drive.
If you change the settings from that at the time of purchase, we recommend
that you make a note of the settings that are changed.
A
Turn on the computer, and press the F2 key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
z
If the password has been set, enter the Supervisor Password, and
press the Enter key.
B Press the F9 key.
At the confirmation message, select [Yes] and press the Enter key.
C Select the [Boot] menu, then select [USB CDD] and press the F6 key until
[USB CDD] is at the top of [Boot priority order].
D Place the Product Recovery DVD-ROM into the DVD-ROM & CD-R/RW
drive.
E Press the F10 key.
At the confirmation message, select [Yes] and press the Enter key.
The Setup Utility will close, and the computer will restart.
z
If the password has been set, enter the Supervisor Password, and
press the Enter key.
3
Use the Product Recovery DVD-ROM to execute reinstalla-
tion.
A Press the 1 key to execute [1. [Recovery]].
(All of the screens below are only examples.)
<When the hard disk backup function has been enabled>
When the message [The Backup function has been enabled. If [Recovery] or
[Erase HDD] is executed, the Backup function will be disabled, and your
Backup data will be lost.] appears, press the Y key.
B
If you agree, press the 1 key.
If you do not agree, press the 2 key.
z
If you press the 1 key the menu will be displayed.
Reinstalling