Panasonic DP-1810F - Manuel (Page 47)

Sending Documents
47
Bas
ic O
p
er
at
io
n
s
If your machine's memory is full or you wish to send the document(s) immediately, use Direct Transmission.
Manual Number Dialing (Direct Transmission)
To dial the telephone number manually, follow the steps below.
Make sure that the FAX/EMAIL lamp is ON. If not, press to select the "FAX/EMAIL MODE".
NOTE
1. If you need a special access number to get an outside line, dial it first then press to
enter a pause (represented by a "-") before dialing the full number.
Ex: 9 PAUSE 5551234
2. If you are using Pulse dialing and you wish to change to Tone dialing in the middle of dialing,
press (represented by a "/").
The dialing mode will be changed from Pulse to Tone after dialing the digit "/".
Ex: 9 PAUSE TONE 5551234
3 To stop the transmission, press .
The display shows:
COMMUNICATION STOP?
1:YES 2:NO
Press to stop the transmission. The Communication Journal will not print out regardless of
the printout mode setting of the Communication Journal.
Direct Transmission
1a
Place original(s) face up on the ADF.
or
ENTER STATION(S)
THEN PRESS START 00%
1b
Place a book or an original face down on the Platen Glass.
Press to select the original size.
2
Make sure that the lamp goes off.
ENTER STATION
THEN PRESS START 00%
3
Enter a telephone number from the keypad.
Ex:
TEL. NO.
5551234
❚
4
Your machine starts dialing the telephone number.
* DIALING *
5551234
1
2 ORIGINAL SIZE
M2/ MEM XMT
5 5 5 1 2 3 4
PAUSE
TONE
STOP
1