Troubleshooting – Panasonic NC-EH40P Manuel d'utilisation

Page 22

Advertising
background image

22

Troubleshooting

Troubleshooting

Before calling a service supplier, please check
the following posible causes/soluting.

If the problem is not fixed after checking the above possible causes, or if you still think something is

wrong, disconnect the body plug from the unit. Wait at least 10 seconds and then re-connect the plug.

The semi-transparent inner part inside the lid may become yellowish. This does not affect operation of the unit.

The ratting noise in the lid is made by small ball-shaped components which prevent water from

flooding out if the unit topples over.

If the room temperature is very high, the outside of the main unit may reach about 131ºF (55ºC).

The unit does
not turn on.

It is broken if the electric

components are taken in
water. Contact the stores
where you purchased
for

repair.

You poured in water directly from a tap.

You put the unit on the sink.

You turned the unit upside down with

its bottom wet.

You washed the unit water.

Possible cause

If...

Causes/Solutions

White or glittering
flakes floating in
the hot water.

The cause of this is “scale”. (See P.20)

It is not flakes of fluororesin.
* Water with a large content of minerals
in it such as mineral water or ionised
water, is more likely to cause a scale
or white layer in the hot water.

When “scale” adhered, boiling sounds

become

louder.

Boiling sounds
become louder.

Odors of chlorine remain depending on

the amount of chlorine in tap water.

Hot water has
odors of chlorine.

When the unit is new, resin used in the manufacturing process may

give off a mild odor.

If the unit is placed on surfaces such as a vinyl sheet, the odor may be

carried over into the water.

Hot water has an
unpleasant odor.

Water has been added above maximum

water

level.

Hot water comes
out by itself.

Lower the water level.

The mesh filter may be clogged with

“scale”. (See P.20)

Hot water does not
flow out smoothly.

Clean the filter with a brush.

If the “scale” cannot be removed,

replace the filter. (See P.23)

Overheating protection has been activated

(See

P.15)

The indicator lights
flash alternaterly.

Add water and press the

“Reboil”

key.

The indicator lights may flash alternately

by adding boiling water or due to the way
the water is supplied.

Press the “Reboil” key.

When the inner container is cleaned with citric

acid, citric acid may have built up on the bottom.

Disconnect the plug, and stir

the citric acid well to disperse.

The automatic lock has been engaged.

Hot water does
not dispense.

Press the “Lock/Unlock” key.

Clean the inner container

with a wet sponge.
(See

P.20)

If the “scale” still remains,

clean with citric acid.
(See

P.21)

Press the “Reboil” key to

reduce the chiorine. (See P.16)

Operating NC-EH40_EN.indd 22

11/7/07 3:57:58 PM

Advertising
Ce manuel est liée aux produits suivants: