KITCHENAID KFBP102LSS - Manuel (Page 3)

3
Side shelves not shown
bottle well
bottle well
holder
two piece
sliding cover
support
frame
single
faucet
ice bin
sink
outlet hose and
connectors
bottle
rail
bottle cap
catch pan
towel
holder
bottle
opener 1-1/2"
drain fitting
1"
drain fitting
Basic Parts of the
Built-in and Portable
models
Installation -
Built-in model
Tools needed:
Excessive Weight Hazard
Use two or more people to move
and install bar cart.
Failure to do so can result in back
or other injury.
WARNING
Use a certified plumber to connect and
install potable water supply and drain
system to outdoor bar cart per local code
requirements.
1.
Set the Bar Cart on a protective
surface such as cardboard or a blanket.
2.
Make sure you have the drain
connections, in accordance with local
codes, under the Bar Cart.
8.
Place a small amount of plumbers
putty around both the ice bin and sink
drain mounting seats.
7.
Install water inlet connection in a
convenient location under the cutout.
Position the water inlet connection so that
the plastic hose easily reaches the filter
inlet connection.
sink
washer
locknut
plumbers putty 5.
Install the faucet and fasten
securely.
6.
Install the water filter on the
sink/faucet side of the cutout. Position the
filter so that the plastic hose attached to
the filter easily reaches the faucet
connection.
plastic hose
connector inlet
connector
nut
mounting
panel
3.
Remove the bottle rail, bottle cap
catch pan and water filter from the ice bin.
4.
Remove the faucet from the sink.
Gather the required tools and parts before
starting installation. Read and follow the
instructions provided with any tools listed.
• Level
• Phillips screwdriver
• tape measure or ruler
• slip joint pliers
• pipe wrench
• adjustable wrench
Parts needed:
• 1-1/2" drain system
• 1" drain system
• NSF- or UPC-listed water connection lines
• plumbers putty
• clear silicon
inlet hose and
connectors
water filter connection
and filter