Operating a cable box or satellite receiver (sat), Setting the manufacturer's code, Operating a cable box or satellite – Sony KP 61S70 Manuel d'utilisation

Page 49: Receiver (sat)

Advertising
background image

45

Setting the Manufacturer's
Code

You can program the supplied remote control
to operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer’s code number (see the
following chart), then press ENTER.
For example, to operate a Sony satellite receiver:

Manufacturer code numbers
(cable box)

Manufacturer

Hamlin/Regal
Jerrold/G.I

Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith

Manufacturer code numbers
(satellite receiver)

Manufacturer

Sony

General Electric
Hitachi
Hughes
Panasonic
RCA/PROSCAN
Toshiba

To operate the cable box or
satellite receiver (SAT)

1

Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
satellite receiver.

2

Press SAT/CABLE (FUNCTION).

3

For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
receiver.

If the remote control doesn’t work
• Try repeating the set up procedures using

the other codes listed for your equipment.

Operating a Cable Box or Satellite Receiver (SAT)

To operate the projection TV

Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.

Tips

z

• If more than one code number is listed, try entering

them one by one until you come to the correct code
for your equipment.

• If you enter a new code number, the code number

you previously entered at that setting is erased.

• In some rare cases, you may not be able to operate

your equipment with the supplied remote control. In
this case, use the equipment’s own remote control
unit.

• Whenever you remove the batteries — to replace

them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.

1

8

0

CODE SET

ENTER

SAT/CABLE

FUNCTION

Code

222, 223, 224, 225, 226

201, 202, 203, 204, 205,

222, 206, 207, 208, 218

227, 228, 229
219, 220, 221

214, 215

209, 210, 211

216, 217
212, 213

Code number

801 (preset code for

remote control)

802, 808

805
804
803
802

806, 807

Advertising
Ce manuel est liée aux produits suivants: